ALSTOM 2013. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is strictly prohibited.

Presentation title - 12/05/2015 P 15

General Inspection Details are briefed

UG 78 : Repairs of Defects in Material

May be, provided acceptance by the Inspector is first obtained for the method and extent of repairs

Inspection and Test

UG 90 : General

UG 91 : Inspector

UG 92 : Access for Inspector

UG 93 : Inspection of Materials

UG 94 : Marking of the Materials

UG 95 : Examination of Surface During Fabrication

UG 96 : Dimension Check of Component Parts

UG 97 : Inspection During Fabrication

UG 103 : MPI as per Appendix 6 and LPE as per Appendix 8.

NDT Related Clauses in Section VIII Div. 1

NDE in ASME