8
TEL: 1-905-738-3986 | FAX: 1-905-738-3928 | Email: [email protected] 399 Four Valley Drive, Unit 22, Concord, ON L4K 5Y7 | www.gamma-nano.ca THE ONLY ONE TO PROTECT YOU AT THE NANOSCALE LEVEL

GammaNano-Motorcycle-MERGED

Embed Size (px)

Citation preview

TEL: 1-905-738-3986 | FAX: 1-905-738-3928 | Email: [email protected] Four Valley Drive, Unit 22, Concord, ON L4K 5Y7 | www.gamma-nano.ca

THE ONLY ONETO PROTECT YOU AT THE

NANOSCALE LEVEL

CO

MM

ON

PR

OB

LEM

S FO

UN

D PLUGSFLOODED FUELCLUTCHGEARBOXALTERNATORIMMOBOLISERENGINE MANAGEMENTENGINE MECHANICALBATTERY

ALL OF WHICH CAN CORRODEAND PRODUCE ELECTRICALMALFUNCTIONING DUE TOMOISTURE, OXIDIZING ANDHARSH WEATHER CONDITIONS.

DON’T LET THESE BE THE REASONFOR NOT ENJOYING YOUR TIMEON THE ROAD.

USE GAMMA NANO, IT’S THEONLY ONE TO PROTECT YOU ATTHE NANOSCALE LEVEL

CAN HELP YOU CUT DOWN ON

all know that motorcycle service is essential. It’s just a fact of life that all components will need to be replaced or adjusted at some point on a bike. The electrical system is a typical example of a system that requires special attention for service and inspection, because of the long life of a classic. For example, the headlight on many older bikes moves with the handlebars, so the wiring will continually move, too. This movement can cause cha�ng and work hardening of the wires (the copper core work hardens) and the associated connectors. It’s important to remove the seat, side panels and fuel tank to check electrical components and the wiring. In addition, the charging and ignition wires should be traced (followed) from the engine to their destination.

Battery Terminals

Shop manuals should be consulted for location of various electrical items. In particular, the main fuse (commonly an in-line fuse) and its housing should be checked. These fuses and their holders are normally located next to the bike’s battery. Corrosion around the batteries connector terminals is common; periodic replacement is the safest way to ensure the fuse holder is in good condition, or regular lubrication (use dielectric grease) as a minimum. Motorcycle batteries are exposed to harsh conditions, much more so than batteries �tted inside a car. The more common lead acid battery will give many years of service if it is regularly maintained.

Voltage Check

A regular check of the battery’s electrolyte solution is essential - distilled water only should be used for topping up. In addition to the water level, the terminals should be checked for tightness and also to remove any corrosion. A voltage check (DC) will reveal a lot about the internal condition of a battery. Any recording below 10 volts (on a 12-volt system) indicates a bad cell necessitating replacement of the battery. All lights and bulbs should be periodically checked for cleanliness and to ensure the connections are not becoming corroded.

Brake Light Switch

Many classic bikes are �tted with the plunger type rear brake light switch. These switches are exposed to the elements and have a tendency to become corroded; typically, the rear brake light will stay on after the pedal is released. Although they can be disassembled and cleaned, it is advisable to replace them if they become corroded.

Ignition systems require very little maintenance other than to check the contact points gap (where �tted) periodically. However, the HT lead and plug cap should be inspected and replaced if they show any signs of aging (typically cracking of the insulation material will be evident).

For the most part, electrical systems will operate trouble free for many miles or years. However, sudden complete failure can, in most cases, be avoided by these simple checks and some basic maintenance.

INTRODUCING NANO TECHNOLOGY AT ITS BEST

4

GAMMA NANO Motorcycle Electrical Insulation builds a long-life protection from all kind of moisture. Nanoparticles penetrate into a structure of the applied surface, displace moisture, and remove oxides. It instantly restores insulation resistance and signi�cantly improves current conductivity. The product penetrates into hard-to-reach spots and can be applied on wet surfaces. GAMMA NANO Motorcycle Electrical Insulation maintains its elasticity for a long time and is harmless on all materials.

FEATURES

MOTORCYCLE ELECTRICAL INSULATION | SKU#2630

This product line was specially developed for scooters, motorcycles, ATVs, hybrid and electric bicycles. What di�erentiates GAMMA NANO from its competitors is the resistance towards heavy mechanical load. Also GAMMA NANO does not absorb moisture, does not contain isopropanol, ethylene glycol and white spirit. It does not evaporate, needs no extra cleaning and greasing of units after use. Extruding moisture, GAMMA NANO safely and reliably isolates electric equipment and electronics (even if it is wet before using GAMMA NANO) and restores its functionality. Prevents the wires and ignition systems of electric motorcycle, scooters, hybrid motorcycle and electric bicycle from getting wet and oxidizing.

PREVENTS SHORTCIRCUIT AND

CURRENT LEAKAGE

DEVELOPED ON THE BASIS OF ADVANCED NANOTECHNOLOGIES

INCREASES SERVICELIFE OF ELECTRICSSAVES REPAIR COST

DISPLACES 100%OF MOISTURE

PROPERTIESBuilds water proof and water repellent coatingCompletely displaces moisture from the applied surfaceImproves strength of dielectric conductivityHelps to avoid freezing and oxidizing of the contactsEliminates soot, carbon deposit and dirtPrevents oxidation, the formation of fungus and mold on electric contactsProtects against static electricity and prevents current leakageCleans and protects the contacts of electric equipment from dust and dirtRestores working capacity and electric conductivity of electronic components and devices damaged by humidity or exposure to waterSigni�cantly increases service life of electrical componentsAllows for driving in extreme weather conditionsDue to powerful capillary e�ect, penetrates inside units without dismantlingFills in microscopic cavitiesMaintains high elasticityDoes not cause harmful e�ects and does not destroy metals, plastic, rubber, glass, varnish, colors, ceramics and electric enginesDoes not dissolve in water

Does not emulsifyRubber, silicone, acrylic, tetra�uoroethylene and aroma freeWeather and temperature resistantHealth and environmentally friendlyOperating temperature range of up to -80°СDepending on the type of application and weather conditions, duration of protective coating may last between 1 to 3 years

The product signi�cantly prolongs the life of motorcycle and bicycle’s metal parts and other moving mechanisms. Apply it to your chains, gears (front and rear), brake cables, threaded connections, moving parts, screw connections, engine and ignition locks. Our product makes them more resilient and can substantially prolong its life cycle.

FEATURESOur product is unique in the complete displacement of moisture. Compared to regular lubricants, GAMMA NANO Motorcycle & Bicycle Anticorrosion Lubricant penetrates, lubricates and protects through long cycles of use. An invisible nanocoating guarantees to stop squeaking and protects from wear and tear for a minimum of one year. Protects metal surfaces and motorcycle/bicycle from rain, dew, fog, chlorinated water and salt water erosion. Restores moisture damaged motorcycle parts and units. Prevents breakage and equipment failure. Our product can e�ectively extend the life of metal parts and units.

MOTORCYCLE & BICYCLE ANTICORROSION LUBRICANT | SKU#2711

HIGH PENETRATINGPOWER

DEVELOPED ON THE BASIS OF ADVANCED NANOTECHNOLOGIES

PREVENTSCORROSION

ELIMINATESSQUEAKING

DISPLACES 100%OF MOISTURE

DOES NOT DISSOLVEIN WATER

PROPERTIESReleases rust build-upsHelps to easily turn o� bolts, nuts, and other screwed connectionsPrevents parts from squeakingPrevents freezing of moving mechanisms Provides stable operation of equipment in winterBuilds water proof and water repellent coatingCompletely displaces moisture from the applied surfaceDue to powerful capillary e�ect, it penetrates inside units without dismantlingFills in microscopic cavitiesMaintains high elasticity

Does not cause harmful e�ects and does not destroy metals, plastic, rubber, glass, varnish, colors, and ceramicsDoes not dissolve in waterDoes not emulsifyRubber, silicone, acrylic, tetra�uoroethylene and aroma freeHealth and environmentally friendlyOperating temperature range of up to -80°СDepending on the type of application and weather conditions, duration of protective coating may last between 1 to 3 years

WHAT IS NANO TECHNOLOGY AND HOW IT WORKS

How does Gamma Nano Anti Corrosion Lubricant operate?

How does Gamma Nano Electrical Insulation operate?

1. Any type of moisture that settles on the metal surfaces leads to corrosion and destruction over time. Getting electrical equipment exposed to any type of moisture will lead to current leakage and short circuits, which in turn can damage electrical devices.

2. GAMMA NANO penetrates at the molecular level into all the micro cracks and uneven parts of the surfaces, creating an invisible protective water repellent �lm. GAMMA NANO will protect even when applied on wet surfaces and will displace 100% of moisture within 10 seconds.

3. GAMMA NANO products are applied through aerosol spray cans. Each can covers up to 27 SQFT.

Nanotechnology is the science, engineering, and technology conducted at the nanoscale, which is about 1 to 100 nanometers.

Nanoscience and nanotechnology are the study and application of extremely small things and can be used across all the other science �elds, such as chemistry, biology, physics, materials science, and engineering.

Displaces 100% of moisture by �lling in micro cracks. It is a powerful protection against any kind of corrosion by creating an invisible nano coating while e�ciently protecting external and internal surfaces of transport vehicles, domestic and industrial equipments, agricultural and building equipments for at least 1 year. Our Gamma Nano Anti Corrosion Lubricant signi�cantly increases service life for all your devices and equipments.

Like our Anti Corrosion Lubricant, our Gamma Nano Electrical Insulation creates a powerful coating that penetrates at the nano scale level and displaces 100% of moisture. In doing so, it not only protects, but also improves dielectric conductivity of surfaces and prevents current leakage, avoids electrical components from freezing and oxidizing of contacts, all the while signi�cantly increasing the service life of all your electrical devices and equipments.

DEVELOPED ON THE BASIS OF ADVANCED NANOTECHNOLOGIES

PREVENTS SHORT CIRCUIT AND CURRENT LEAKAGE

INCREASES SERVICELIFE OF ELECTRICS

SAVES REPAIR COST

DISPLACES 100% OF MOISTURE

TOP RANK DURABILITY

LIFELONG PROTECTION

MAINTAINS ITS ELASTICITY FOR LONG TIME

STABLE INVISIBLE COATING

PREVENTSCORROSION

OPERATING TEMPERATUREUP TO

-80°С

NEXT GENERATION PENETRATING LUBRICANT

PROTECTIVE COATING FOR AT LEAST ONE YEAR

ONE SPRAY CAN COVERS UP TO 27 SQUARE FOOT

5

6

Determine the degree of conformity of the NANOPROTECH product’s protective properties. The testing procedure is based on comparison of corrosion test results on samples before and after application of the aerosol. The contactless transformers installed in distribution cabinets were used as

samples and were exposed to corrosion due to high humidity (up to 100%) and high temperature (up to 35C). Test conditions were conducted in the period from 26.04.10 to 18.05.11 at ambient condi-tions.Conclusion: the tested tool has truly anti-corrosion and dielectric properties and is suitable for use on switching nodes of communication facilities operating in conditions of high humidity and high temperatures.

Chief engineer of Central telecom center No2,Nasonov M.V.

Scope of testing:

DON’T WORRY, WE’VE DONE OUR DUE DILIGENCE ANDCOMPARED OURSELVES WITH OUR COMPETITION...THERE ARE NONE!

SGS Test Results | Report No.: H0RD0002

Metal Plate #1 after 96h salt fog exposure Metal Plate #2 after 96h salt fog exposure Metal Plate #3 after 96h salt fog exposure Metal Plate #4 after 96h salt fog exposure

NANOPROTECH OÜ Uus-Sadama, 21, Tallinn, 10120, Estonia

Certificate Of conformity with RoHS (2002/95/EC)

Issued: __________________________________ Indrek Aeltermann Member of the Board

Certificate of conformity with REACH (EC1907/2006)

7

Gamma Nano Auto Deodorizer eliminates unpleasant odors caused by smoke, food, mildew and pets. Reduces odors by maximizing the oxidation process through the photocatalysis e�ect of visible light. For use on cars, public transit, trains, airplanes and other modes of transportation.

When exposed to visible light, Gamma Nano breaks down and eliminates all allergens, odors, and air pollutants in your vehicle, purifying and protecting your car’s interior for a fresher and healthier driving experience.

WHY GAMMA NANO AUTO DEODORIZER?Over the past two decades, studies have consistently revealed that driving in tightly packed tra�c leads to interior concentrations of pollutants up to 50 times higher than that of normal city air. Many of the pollutants are suspected to be carcinogens that can a�ect neurological, immune and reproductive systems.

According to the United States Environmental Protection Agency (EPA) and the American Lung Association (ALA), inside air is 10 times more polluted than outside air, with car interiors ranking alongside industrial plants for air quality.

With Gamma Nano Auto Deodorizer, you can literally breathe easier. Just one application of Gamma Nano is all it takes to make your car deodorized and the air in your car clean and pure. You’ll immediately notice the di�erence.

Gamma Nano not only removes contaminants from the air but also prevents them from coming back, keeping the air in your car fresh and odor-free.

VISIBLE LIGHT

PHOTOCATALYST (TiO )2

REACTOR SURFACE

POLLUTANTSABSORB TO SURFACE

ABSORBED POLLUTANTS BREAKDOWN UNDER UV LIGHT

FINAL PRODUCTS(CO AND WATER DESORB)

FEATURES

SKU#2500

Decomposes odor, smell, and Volatile Organic Compounds (VOC) such as Formaldehyde (CH O), Acetaldehyde(CH CHO)Decomposes organic stains on the surfacePrevents surfaces as a medium of transmission of infectionLonger term antimicrobial anddeodorant e�ectGreen and eco-friendly

APPLICATIONSSpray it on the surface of absorbent materials, textiles and furniture such as seats, ceilings, carpets, dashboards, trunks, door panels.

2

2

THE ONLY PRODUCT IN THE WORLD TO GUARANTEE EFFECTIVENESS FOR UP TO ONE YEAR.

DRIVERS CAN DRIVERS SPEND AN INCREDIBLE AMOUNT OF TIME IN THEIR VEHICLE

UNMATCHED | UNRIVALED | TRUE TESTED

TEL: 1-905-738-3986 | FAX: 1-905-738-3928 | Email: [email protected] Four Valley Drive, Unit 22, Concord, ON L4K 5Y7 | www.gamma-nano.ca