Sonny Contat

Front Panel IkeaLack Table 3 Buttons(with Prusa Logo)

VIEW IN BROWSER

updated 15. 8. 2019 | published 15. 8. 2019

PRUSAPRINTERS

Summary

I wanted to have a nice front panel for my Ikea Lack Enclosure with somebuttons to turn on the printer, some LED and the Raspberry Pi.

I designed this really simple front panel with three holes (20mm) for thebuttons and on the other side, added the Prusa logo to make it nicer :)

The Switches that I used are from Mountain Switch (Model : R13-135). Youcan find them with or without the light and also in other colors. I find themon Mouser Electronics and they ship Worldwide.

There is two STL, one for the buttons and the other with the logo. I put thetwo on the gcode and you can print them together on the same plate.

Modify it as you want and Rate it if you downloaded it :)

Don't hesitate to leave a comment if you have a question and a Make ifyou made it.

Thanks for the support

UPDATE 1 : I added some supports on the back of the front panel due tothe pressure on the buttons

22 hrs

2 pcs

f

0.15 mm

k

0.40 mm

h

PLA

203 g

d

MK3/S

Print Files (.gcode) DOWNLOAD ALL FILES

24.5 MB

14.78 hrs f 0.15 mm k 0.40 mm h PLA 135.00 g d MK3/S

updated 15. 8. 2019

4.8 MB

7.12 hrs f 0.15 mm k 0.40 mm h PLA 68.00 g d MK3/S

updated 15. 8. 2019

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

UPDATE 2 : I Installed mine with some strong double sided tape and thereis enough contact surface to hold the pieces and nothing moves.Everything works fine.

UPDATE 3 : I made a second version of the buttons side to fit some roundM19 switches that you can find here : https://www.ebay.com/itm/1pc-Metal-Flat-Blue-Led-Push-Button-Waterproof-Resetable-Switch-19mm-QN19-C5-/223013789312

3D Printers > 3D Printers - Upgrades

panel frontpanel buttons ikea pi raspberry lack

mk3 front led table prusa

Print in 0.15 or 0.2 with the front face down to have a nice first layer.

Use supports from the build plate for supporting the bezels and the holes.

Be patient during approximately 14 hours and don't forget to eat gummybears and to drink water :)

front_panel_complete_015mm_pla_mk3.gcode

roundbutton_015mm_pla_mk3_7h7m.gcode

2.0 MBupdated 15. 8. 2019

718.1 KBupdated 15. 8. 2019

2.0 MBupdated 15. 8. 2019

Find source .stl files on Thingiverse.com

License

This work is licensed under a Creative Commons (4.0 International License)

Attribution-ShareAlike

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition

front_panel_button.stl

front_panel_logo.stl

roundbutton.stl