Upload
diego-garzon
View
222
Download
5
Embed Size (px)
DESCRIPTION
Formato API
Citation preview
API STANDARD 1104
Reference: API Standard 1104, 5.2
PROCEDURE SPECIFICATION NO. __________
For _________________________________________ Welding of ________________________________________ Pipe and fittings Process _____________________________________________________________________________________________________Material _____________________________________________________________________________________________________
Diameter and wall thickness ______________________________________________________________________________________
Joint design __________________________________________________________________________________________________
Filler metal and no. of beads _____________________________________________________________________________________
Electrical or flame characteristics __________________________________________________________________________________
Position _____________________________________________________________________________________________________
Direction of welding ____________________________________________________________________________________________
No. of welders ________________________________________________________________________________________________
Time lapse between passes _____________________________________________________________________________________
Type and removal of lineup clamp _________________________________________________________________________________
Cleaning and/or grinding ________________________________________________________________________________________
Preheat/stress relief ____________________________________________________________________________________________
Shielding gas and flow rate ______________________________________________________________________________________
Shielding flux _________________________________________________________________________________________________
Speed of travel ________________________________________________________________________________________________
Plasma gas composition _______________________ Plasma gas flow rate _______________________________________________
Plasma gas orifice size _________________________________________________________________________________________
Sketches and tabulations attached ________________________________________________________________________________
Tested ________________________________________Welder ________________________________________________
Approved ______________________________________Welding supervisor ______________________________________
Adopted _______________________________________Chief engineer __________________________________________
1/16" (1.6 mm)
1/32" 1/16" (0.8 1.6 mm)
T
Approximately 1/16" (1.6 mm)1/16" 1/32" (1.6 mm 0.8 mm)
Standard V-Bevel Butt Joint
5Approximately 1/8"
(3 mm)
4
3
T
2
1
Sequence of Beads
Note: Dimensions are for example only.
ELECTRODE SIZE AND NUMBER OF BEADS
ElectrodeAmperage
Size andand
Bead NumberTypeVoltagePolaritySpeed
Figure 1Sample Procedure Specification Form