FLAME SAFEGUARD Bulletin March 1992 FLAME MONITOR MICROPROCESSOR BASED BURNER MANAGEMENT CONTROL WITH MESSAGE CENTER AND SEL AG Photocell UV Scanner UV Scanners UV Scanners Flame Rod Scanner DESCRIPTION The System is a microprocessorbased,burner management control system with self-diagnostics,non-volatile memory and vocabulary of 42 different messages which scroll out on the message center to provide the operator with status and failure mode information. The FLAME- MONITOR Series is designed to provide the proper burner sequencing, ignition and flame monitoring protection on automatically ignited oil, gas and combination fuel burners. In conjunction with limit and operating controls,it programs the motor, ignition and fuel valves to provide for proper and safeburner operation. On a safety shutdown, the message center will advise the operator that the control is in “lockout’ and scroll a message indicating the cause as well as the position in the sequence it occurred. Interchangeable programmer and flame amplifier modules allow for complete versatility in selection of control function, timing and flame scanning means. Functions such as pre-purge timing, recycling interlocks, high fire proving interlock and trial for ignition timing of the pilot and main flame are determined by the programmer module. The FLAME- MONITOR can be used with ultraviolet, autocheck infrared, photocell, flame rod or self-check ultraviolet flame scanners by choosing the proper amplifier module. The eighteen terminal wiring base allows for many functional circuits including motors, valves and ignition transformers as well as multipleinterlocks such as hi-purge, low purge, fuel valve and running circuits. The FLAME-MONITOR uses the same wiring base as the D Series and C Series Controls and is designed to be directly interchangeable with most models without rewiring.

FLAME MONITOR - Fireye · autocheck infrared, photocell, flame rod or self -check ultraviolet flame scanners bychoosing the proper amplifier module. The eighteen terminal wiring base

Download PDF Report

Upload
others
View
11
Download
0

Embed Size (px)

Citation preview

Page 1: FLAME MONITOR - Fireye · autocheck infrared, photocell, flame rod or self -check ultraviolet flame scanners bychoosing the proper amplifier module. The eighteen terminal wiring base

FLAME SAFEGUARD BulletinMarch 1992

FLAME MONITORMICROPROCESSOR BASED BURNER

MANAGEMENT CONTROL WITHMESSAGE CENTER AND

SEL AG

Photocell UV Scanner UV Scanners

UV Scanners Flame Rod

Scanner

DESCRIPTIONThe Systemis a microprocessorbased,burner management controlsystem with self-diagnostics, non-volatile memory and vocabulary of 42 different messages whichscroll out on the message center to provide the operator with status and failure mode information.

The FLAME-MONITOR Series is designed to provide the proper burner sequencing, ignition andflame monitoring protection on automatically ignited oil, gas and combination fuel burners. Inconjunction with limit and operating controls,it programs the motor, ignition and fuelvalves to provide for proper and safeburner operation. On a safety shutdown, the message center willadvise the operator that the control is in “lockout’and scroll a message indicating the cause as wellas the position in the sequence it occurred.

Interchangeable programmer and flame amplifier modules allow for complete versatility in selectionof control function,timing and flamescanning means. Functions such aspre-purge timing,recyclinginterlocks, high fire proving interlock and trial for ignition timing of the pilot and main flame aredetermined by the programmer module. The FLAME-MONITOR can be used with ultraviolet,autocheck infrared, photocell, flame rod or self-check ultraviolet flame scanners by choosing theproper amplifier module.

The eighteen terminal wiring base allows for many functional circuits including motors, valves andignition transformersaswell as multipleinterlocks suchashi-purge, lowpurge, fuelvalveandrunningcircuits. The FLAME-MONITOR uses the same wiring base as the D Series and C SeriesControls and is designed to be directly interchangeable with most models without rewiring.