Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Fire Hose DummyHow to make a hose dummy for training
Roll out 3 lengths 1-3/4 hose and
connect.Align all 3 parallel.
Bring all lengths tight together.
Fold the lengths back on
themselves by pulling the middle.
Make all 6 pieces parallel and
upright.
Make an arm by pulling up one side
into a loop.
Make the other arm. Adjust and neaten.
Pull one side up into the torso,
leaving a long loop for the leg.
Pull the couplings up into the torso.
Tease one length out of the torso and
out into the arm.
Feed it neatly into the arm, up the
neck and into the head.
Feed around neatly into head until the
leftover goes straight into torso.
Repeat the process to build the other
leg.
Tease a piece out into the other arm.
Bring it around into the head until you find a nice pocket for the coupling.
Neaten and adjust. Looks good. Let’s secure it.
Get 7 LARGE zip ties.
Secure the top and bottom of the torso.
Make a zip tie loop around each
shoulder. Leave loose.
Zip tie around the neck, passing through each
shoulder.
Snug 3 interlaced zip ties evenly and trim all ends with
snips.
A smaller zip tie will reinforce the larger
torso ties.
Place reinforcing tie in this fashion
and tighten.
Tape multiple places on torso.
Ensure couplings can’t fall out.
Tape 3 places on each leg.
Shape your arm before taping.
Tape each arm twice, and tape the
neck.
Make your dummy a friend and go
TRAIN!