Upload
silvester-richardson
View
215
Download
0
Embed Size (px)
Citation preview
Fat Max VEX Organizing System
These photographs show how a complete VEX kit can be stored in a Fat Max organizing system, containing three trays.
Components are organized by size and by function.
Tanya Faltens Last updated 6/24/12
Top Tray with Handle
Tools and longer axles
Short plates and brackets
Plastic pieces for slider
Long slider pieces
Deep Space under the Top Tray
All of the long “L” shaped pieces stack together along 2 edges
All of the plates and long “C” shaped pieces fit along the bottom
4 largest wheels
Pull-out drawer
2 Smart chargers and power cables.
4 Medium wheels
Claw. Motor can remain attached.
Batteries and A-A USB cables.
Other charger. batteries could go here.
2 VEX Cortexes
8-32 ¼”
6-32¼”
8-32 ½”
8-32 5/8”
8-32 ¾”
8-32 1”
6-32¾”
Square shafts
Threaded standoffs
Shaft collars
washers
Delrin bearing flats
KEPS nuts ties
nylock nuts
Delrin bearing blocks
spacersPop rivets
LEDs
Potentio-meters
Line followers
Limit Switches
Bump Switches
269 Motors
269 Motors
2 wire motor adapters
Extension wires
Various small Gears
Place the larger parts that are least likely to slip through near the top of the case.
Put copious small parts near the bottom of the case