Upload
roji-philip-n
View
214
Download
0
Embed Size (px)
Citation preview
7/26/2019 F0104 Watermark
1/1
Follow these steps and click the corresponding movie for the
procedure to import a Watermark into an InfoAlarm Display
(Adobe Reader 9 or later is required to correctly viethis document Click hereto download the free view
2011 Tyco Safety Products, All Rights Reserved.
F010
How to Import a Watermark
into an InfoAlarm Display
4100ES
International Trade Controls and Restrictions
This material may contain information or technology the export or re-export of which is restricted by U.S. laws and regulations. By viewing this material, the recipient agrees to the following: (i) the recipient's use of
contents of this material shall comply with all applicable laws, rules and regulations, including, without limitation, U.S. international trade laws and regulations, and (ii) the recipient may not transfer or otherwise expo
re-export any information or technology contained in this material except in full compliance with the export controls administered by the U.S. and other countries and any applicable import and use restrictions.
To give us feedback, click he
1. Open the Job File folder and create a folder named Bitmap.
2. Add the InfoAlarm bitmap (.bmp) file to this new folder.
3. From the ES Programmer, click the FUI tab.
4. Click the Enable Watermark Bitmap checkbox and then click the Import Bitmap button.
5. Double click the .bmp file and a preview of the bitmap appears in the Watermark field.
6. Download to the FACP and the Watermark appears on the InfoAlarm display.
http://get.adobe.com/reader/mailto:[email protected]?subject=F0104%20Tutorial%20Feedbackmailto:[email protected]?subject=F0104%20Tutorial%20Feedbackhttp://get.adobe.com/reader/