Expedient Homemade Firearms

.32/380 Machine Pistol MKII

Expedient Homemade Firearms

.32/380 Machine Pistol MKII

Expedient Homemade Firearms

The upper and lower receiver

assembly (Measurements in millimetres)

With the upper and lower receiver assembly clamped together with two hose clips, the upper receiver must overlap the lower by 6mm, as shown at ‘A’. The slot for the trigger ‘B’, is positioned 58mm from the rear end of the receiver and is 17mm in length. The slot for the trigger guard, ‘C’, is positioned 51mm from the front of the receiver and is 3mm in length and 12.7mm (1/2”) in width.

Hose Clips

.32/380 Machine P

istol MK

II

LOWER RECEIVER ASSEMBLY

The trigger guard, grip, and socket screws are secured in place using silver solder at points ‘a’ ‘b’ ‘c’ and ‘d’. The socket screw ‘d’ allows the sear spring to be attached to the receiver.

Expedient Homemade Firearms

TEMPLATES

.32/380 Machine Pistol MKII

FULL

Y A

SS

EM

BLE

D L

OW

ER

RE

CE

IVE

R

Expedient Homemade Firearms

.32/380 Machine Pistol MKII

Expedient H

omem

ade Firearms

.32/.380 Machine Pistol Mark II

This schematic drawing shows the simplicity of the MKII design.