Click here to load reader
Upload
allan-ray
View
141
Download
0
Embed Size (px)
Citation preview
Review of Mapping Techniques for Geologic Mapping, Ore Estimation and Modelling
Explain in DETAIL (include figures) how the following are done. (100 pts)
1) How to make a cross section using a topographic map (10 pts, no illustration: -10 pts)
2) Outcrop patterns on a topographic map for:(10 pts each)
- Horizontal planes (beds, faults)
- Vertical planes
- Tilted planes
* this is not the rule of V’s
** show step by step solutions and illustrations (noncompliance: -30 pts)
3) Area estimation for irregular solids. (10 pts)
4) How to acquire the volume of a tilted layer (or bed) confined in a box. (10 pts, no figure -10 pts)
5) Strike and dip of a plane using 3 points (3 point problem). 10 pts (no illustration: -10 pts)
6) Parts of a Brunton Compass. (10 pts)
7) Strike and dip of a plane using a Brunton compass. (10 pts)
Reminders
Incomplete submissions can only get a maximum grade of 30/100
must be HANDWRITTEN (typewritten submissions will get an automatic grade of zero (0/100)
all figures must be hand drawn or sketched except for topo maps and brunton compasses (all
other markings such as construction lines or planes must be sketched. (noncompliance = 0/100)