EX5T5, T5HO, T8, T8HO

FLUORESCENT LUMINAIRES

OUTDOOR LINEARLIGHTING

Prefix Mounting Optics Lamp Wattage Length Volts Finish Options & Accessories

EX5 SMS - surface mount single fixtureSMM - surface mount multiple fixtures

EAS - extended arm single fixtureEAM - extended arm multiple fixtures

PNS - pendant mount single fixturePNM - pendant mount multiple fixture

CDS - conduit mount single fixtureCDM - conduit mount multiple fixtures

PNS90 - pendant mount 90° single fixture*PNM90 - pendant mount 90° multiple fixtures*

Multiple fixture runs are available up to 100' maximum.

SA - single lamp in cross section, asymmetric

TA - twin lamp in cross section, asymmetric

T5

T5HO

T8

T8HO

T5

T5HO

14W21W28W

24W39W54W

17W25W32W

44W65W86W

(remoteballast)

14W21W28W

24W39W54W

2'3' , 6'4' , 8'

2'3' , 6'4' , 8'

2'3' , 6'4' , 8'

4' , 8' 6'8'

2'3' , 6'4' , 8'

2'

3' , 6'4' , 8'

1 - 120V

2 - 277V

7 - 347V(contact factory)

TW - textured white

TBL - textured black

TBR - textured bronze

TN - textured natural

TS - textured sand-stone

TLB - textured lightbronze

SF - specify finish (see color chart)

CC - custom color (contact factory)

PL - prismatic acrylic lens (8' maximum)

PC - clear polycarbonate lens

L V - louver

VS - visor

DM - dimming ballast (contact factory)

WCF - color lens (contact factory for color selection)

EM **- ememrgency circuit

EPF - power feed through LH end cap (6' power feed standard)

• NOTES * PNS90 & PNM90 - Please consult with factory for lead times.• **EmergencyCircuits-Discretepowerleadstobewiredtoaremotegeneratorset,etc.,minimum2lampfixture,pleasecontactfactory

SPECIFICATIONS

Housing: The EX5 housing is an extruded aluminum housing with single piece, die-cast endcaps. Mounting: All mounting options attach to cast aluminum knuckles, allowing for ajustment of the luminaire. Lens: An extruded aluminum, hinged doorframe with a .187" virgin acrylic lens is retained to the housing with stainless steel bolts and inserts. A single piece, memory retenvie gasket provides a seal between the doorframe and housing.

Reflector: CAD designed, die cut, 95% specular, peened, anodized aluminum reflectors are asymmetric. All photometry is independently tested.

Electrical: Integral electronic ballasts with a power factor greater than .90 are standard. Thermally protected, <10% THD ballasts have a starting temperature of 0°F. T8HO ballasts are remote and have a -20°F starting temperature.

Finish: All surfaces are multi-stage pretreated and coated with UV inhibited, dry polyester powder paint, providing a textured finish.

Labels: UL/CUL approved for wet locations.

InsightLightingreservestherighttochangespecificationswithoutnoticedue to product improvements.

Ordering Example: EX5/SMS/SA/T5/54/4/2/TLB

Rio Rancho, NM 87144Tel: 505-345-0888www.insightlighting.com

12/13/2012 Page 1 of 6

Prefix Mounting Optics Lamp Wattage FixtureLength Volts Finish Options & Accessories

TYPE: ________________________________

JOB NAME: ___________________________

APPROVAL: ___________________________

(SMS MOUNT SHOWN)

EX5T5, T5HO, T8, T8HO

FLUORESCENT LUMINAIRES

OUTDOOR LINEARLIGHTING

SMS/SMM - Surface Mount Single / Multiple fixturesDie cast knuckles allow for ajustment of the luminaire; the wall brackets are constructed of heavy gauge zinc plated steel and have a gasketed

access cover, allowing access to a recessed j-box (by others).

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 2" 2' 2" 3' 2" 5' 2" 7' 2"

Nominal Length(START)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(END)

OVER-ALL LENGTH

SMS - Surface Mount Single

SMM - Surface Mount Multiple

Sequence of fixtures must be identified in multiple fixture runs.Use table below to arrange Nominal Lengths of START, MID, and END fixtures to equal OVER-ALL desired length.

*INSIGHT LIGHTING reserves the right to arrange fixtures as seen fit if sequence is not indentified by customer.

*OVER-ALL LENGTH is Nominal; Refer to Mounting Table for exact fixture dimensions.

Rio Rancho, NM 87144Tel: 505-345-0888www.insightlighting.com

12/13/2012 Page 2 of 6

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 8" 2' 8" 3' 8" 5' 8" 7' 8"

EX5T5, T5HO, T8, T8HO

FLUORESCENT LUMINAIRES

OUTDOOR LINEARLIGHTING

EAS/EAM - Extended Arm Single / Multiple fixturesDie cast knuckles allow for ajustment of the luminaire; Extended arms are constructed of steel tubing with an applied zinc coating prior to powder painting, welded to heavy gauge zinc plated steel wall brackets. The wall brackets have a gasketed access cover, allowing access to a recessed j-box (by others).

Rio Rancho, NM 87144Tel: 505-345-0888www.insightlighting.com

12/13/2012 Page 3 of 6

EAS - Extended Arm Single

EAM - Extended Arm Multiple

Nominal Length(START)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(END)

OVER-ALL LENGTH

Sequence of fixtures must be identified in multiple fixture runs.Use table below to arrange Nominal Lengths of START, MID, and END fixtures to equal OVER-ALL desired length.

*INSIGHT LIGHTING reserves the right to arrange fixtures as seen fit if sequence is not indentified by customer.

*OVER-ALL LENGTH is Nominal; Refer to Mounting Table for exact fixture dimensions.

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 2" 2' 2" 3' 2" 5' 2" 7' 2"

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 8" 2' 8" 3' 8" 5' 8" 7' 8"

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 2" 2' 2" 3' 2" 5' 2" 7' 2"

PNS/PNM - Pendant Mount Single / Multiple fixturesDie cast knuckles allow for ajustment of the luminaire; pendants are made from 3/8" ID steel pipe with an applied zinc coating prior to powder painting. The wall brackets have a gasketed access cover, allowing access to a recessed j-box (by others).

EX5T5, T5HO, T8, T8HO

FLUORESCENT LUMINAIRES

OUTDOOR LINEARLIGHTING

Rio Rancho, NM 87144Tel: 505-345-0888www.insightlighting.com

12/13/2012 Page 4 of 6

PNS - Pendant Mount Single

Nominal Length(START)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(END)

OVER-ALL LENGTH

Sequence of fixtures must be identified in multiple fixture runs.Use table below to arrange Nominal Lengths of START, MID, and END fixtures to equal OVER-ALL desired length.

*INSIGHT LIGHTING reserves the right to arrange fixtures as seen fit if sequence is not indentified by customer.

*OVER-ALL LENGTH is Nominal; Refer to Mounting Table for exact fixture dimensions.

PNM - Pendant Mount MultipleNominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 8" 2' 8" 3' 8" 5' 8" 7' 8"

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 2" 2' 2" 3' 2" 5' 2" 7' 2"

PNS90/PNM90 - Pendant Mount 90° Single / Multiple FixturesDie cast knuckles allow for ajustment of the luminaire; pendants are made from 3/8" ID steel pipe with an applied zinc coating prior to powder painting. The wall brackets have a gasketed access cover, allowing access to a recessed j-box (by others).

EX5T5, T5HO, T8, T8HO

FLUORESCENT LUMINAIRES

OUTDOOR LINEARLIGHTING

Rio Rancho, NM 87144Tel: 505-345-0888www.insightlighting.com

12/13/2012 Page 5 of 6

PNS90 - Pendant Mount 90° Single

PNM90 - Pendant Mount 90° Multiple

Nominal Length(START)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(END)

OVER-ALL LENGTH

Sequence of fixtures must be identified in multiple fixture runs.Use table below to arrange Nominal Lengths of START, MID, and END fixtures to equal OVER-ALL desired length.

*INSIGHT LIGHTING reserves the right to arrange fixtures as seen fit if sequence is not indentified by customer.

*OVER-ALL LENGTH is Nominal; Refer to Mounting Table for exact fixture dimensions.

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 2" 2' 2" 3' 2" 5' 2" 7' 2"

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 8" 2' 8" 3' 8" 5' 8" 7' 8"

CDS/CDM Conduit Mount Single / Multiple FixturesDie cast knuckles allow for ajustment of the luminaire and are threaded to accept standard 3/4" rigid conduit (by others).

EX5T5, T5HO, T8, T8HO

FLUORESCENT LUMINAIRES

OUTDOOR LINEARLIGHTING

Rio Rancho, NM 87144Tel: 505-345-0888www.insightlighting.com

12/13/2012 Page 6 of 6

CDS - Conduit Mount Single

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 8" 2' 8" 3' 8" 5' 8" 7' 8"

'C' 1' 10" 2' 10" 3' 10" 5 10" 7' 10"

CDM - Conduit Mount Multiple

Nominal Length(START)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(MID)

Nominal Length(END)

OVER-ALL LENGTH

Sequence of fixtures must be identified in multiple fixture runs.Use table below to arrange Nominal Lengths of START, MID, and END fixtures to equal OVER-ALL desired length.

*INSIGHT LIGHTING reserves the right to arrange fixtures as seen fit if sequence is not indentified by customer.

*OVER-ALL LENGTH is Nominal; Refer to Mounting Table for exact fixture dimensions.

Nominal LengthSingleFixture

2' 3' 4' 6' 8'

'A' 2' 2" 3' 2" 4' 2" 6' 2" 8' 2"

'B' 1' 4" 2' 4" 3' 4" 5' 4" 7' 4"