Upload
anmol-jain
View
240
Download
0
Embed Size (px)
DESCRIPTION
Simulation , Layout and observations for different width to length ratio of driver and load are mentioned in document with appropriate screenshots that will help the user to verify their report.
Citation preview
7/17/2019 Enhancement Type Inverter Simultion and layout in Microwind
http://slidepdf.com/reader/full/enhancement-type-inverter-simultion-and-layout-in-microwind 1/3
Experiment-3 enhancement load inverter
Schematic
Layout
(W/L) Driver = (W/L) Load =2.5
Wnd = Wnl= 5 λ, Lnd = Lnl = 2 λ.
Vdd=Vgg=1.2V.
7/17/2019 Enhancement Type Inverter Simultion and layout in Microwind
http://slidepdf.com/reader/full/enhancement-type-inverter-simultion-and-layout-in-microwind 2/3
Experiment-3 enhancement load inverter
wavform
Vtc characteristic
7/17/2019 Enhancement Type Inverter Simultion and layout in Microwind
http://slidepdf.com/reader/full/enhancement-type-inverter-simultion-and-layout-in-microwind 3/3
Experiment-3 enhancement load inverter
Noteworthy Observation:
In general we consider K R = ((W/L) Driver / (W/L) Load) =1 thus no effect is seen when we
vary both simultaneously. But when we keep (W/L) Driver =2.5 and vary (W/L) Load= 1.67
then the rise and fall time increases but on doing opposite i.e. when we keep ((W/L) Load
=2.5 and vary (W/L) Driver = 1.67 then the rise and fall time of the output voltage
decreases.
The effect of varying the supply voltage can be marginally seen only the current drawn
from the circuit increases which in turn increases power consumed.
5. Conclusion/Learning Outcome:
An exact inverted input at the output is not observed as for high input the output obtained
is not zero but VOL =0.410V while for low input voltage the output is not high but VOH
=0.680V.
Current only flows when the driver transistor is in ‘linear or saturation mode’. But the
effect of the leakage current can be seen as when the driver transistor is in off state the
output should be high(vdd) but we see that some voltage drop occurs within the circuit
through nmos driver thus the output voltage is VOH =0.787V when input voltage is zero.