ENGINE REMOVAL and DISASSEMBLY

Chapter 7 Classroom Manual Page 157

CBCAUTOMOTIVERK

OBJECTIVES

Describe the steps required to prepare the engine for removal.

Describe the basic method of removing an engine on most front wheel drive vehicles.

Describe the basic method of removing an engine on most rear wheel drive vehicles.

Explain the procedure of removing heads.

CBCAUTOMOTIVERK

OBJECTIVES 2

Describe the basic procedures for removing block components.

List considerations made when selecting a cleaning method.

Describe the various methods of chemical cleaning the engine components after disassembly.

CBCAUTOMOTIVERK

INTRODUCTION

Not all engine repair operations require engine removal.

The engine must be removed when performing a complete rebuild.

Most cars are FWD. Most trucks are RWD. Completely disassembly after

removal.

CBCAUTOMOTIVERK

PREPARING the ENGINE for REMOVAL

Develop a plan for removing the engine.

Determine what tools are needed. Study recommended procedure. Position chain directly over center

of engine. Disconnect Battery. See caution.

CBCAUTOMOTIVERK

Page 157 Class 149 Lab

ENGINE REMOVAL

Take pictures. Mark hoses. Mark brackets. Drain all Fluids from engine, keep

separate. Freon must be reclaimed. Remove all accessories from engine.

CBCAUTOMOTIVERK

Page 159 Class

REMOVING THE ENGINE

Protect paint and finish of the vehicle. Protect radiator and/or condenser. Support the transmission/transaxle. Remove engine from above if possible. Use factory lift points. Fig P7-2, p157

Lab Lengthening boom decreases lifting

capacity.

Page 161Class

CBCAUTOMOTIVERK

ASSIGNMENT

Write a engine removal procedure for the vehicle you will be rebuilding the engine on.

Due tomorrow. 10/14/94 7:15 Am..

CBCAUTOMOTIVERK