MBobbinHolder
2. FIT THE BOBBIN ON THE BOBBIN HOLDERHoltling the Bobbin Holder
in the Let Hand, fit theBobbin on to the Bobbin Holder and turn the
Bobbinto the Righr as far as possible
.eBobbin
4. WINDING THE WOOLThread the Wool through the Yarn Guideand
hook the end of the Wool in thegap in the Bobbin.Then, holding the
Wool to give it aslight tension, turn the Handle to the Right.
For Cotton Yarn or Synthetic WoolDo not take the Ball off
theBobbin
-
rmove the Bobbin fromrhe Bobbin Holder and use theWool rom the
outside of the Ball.
3.
I. SET UP THE YARN GUIDEUsing the slot-
On the lelt side for aright-handed person
-
On the right side for aleft -handed person,
lnsert the yarn guide asar as possible
5. AFTER WINDING UP THE WOOLPull out the beginningof the Wool
and take theBall off the Bobbin.For Cotton Yarn or
SyntheticWool
-
See ltem 6.2
c LAMp rH -,E wootw_t NgE RlQ}lJAgt E
Turn the Holding Clamp to the Bottom as shown.Fit on the table
and secure by turning theWing Nut to the Right.
6.
(l)KNI]-]].NGFor Waol
Takc rrp from theinside of the Ball.
@
ighten
HOW TO USE YOUN WOOLWINDER
