1
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 Electronics line (E.L) Ltd. - Summit 3208GLD Household Burglary and Fire Alarm Panel Connector for plug-in relay module PROTECTION FUSES F1 (BATT): 3A/250V (bel 5MF3) F2 (AUX): 1.6A/250V (bel 5MF1.6) F3 (BELL): 3A/250V (bel 5MF3) Install F3 horizontally to supply 12v nominal regulated power to bell. Install vertically to supply 9-18V unregulated to bell and terminal 28. Electronics line (E.L) recommends testþng the system at least once a week. Rafer to the testing procedure found in the installation manual Receiver communication must be tested monthly. For maximum current calculation, add keypad consumption (approx. 60mA per keypad) tý the total current drawn from the AUX power output. System Bus Connector 12V 7Ah BATTERY Charging current 700mA max. Replace the battery every 3 - 5 years AUXILIARY POWER OUTPUT Regulated 12VDC nominal. Fire: Supplies 220mA for 24 hours Burglary: Supplies 1A for 4 hours (inclýding 100mA to smoke detector. terminasl 24 and 25) LED SYSTEM STATUS INDICATOR On = Telephone Tone Detection Off = System in Communication Flashing = Dialing Flashing (1 pulse/sec) = Standby RED BLACK F1 F3 F2 WHITE GREEN RED BLACK Telephone Line Connections 3108/3118/3126 LCD Keypad 3106 LED Keypad System Bus Z1 Z2 Z3 Z4 Z5 Z6 Z7 Z8 Zone Connections N.C. N.C. 2.2K 2.2K Typical End of Line Resistýr Zone Connections (EOLR) Power connection to the unit should be according to the national electrical code for permanent installation Mic Input (-) (+) Siren Audio Output 600mA AUX Power Output Smoke Detector Output 12V nominal max. 100mA Unregulated Power Output (9-18V) Transformer 15VAC/30VA Connect to Earth

Electronics Line 3208 Esquema Conexiones

  • Upload
    redo80

  • View
    145

  • Download
    1

Embed Size (px)

Citation preview

Page 1: Electronics Line 3208 Esquema Conexiones

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Electronics line (E.L) Ltd. - Summit 3208GLD Household Burglary and Fire Alarm Panel

Connector forplug-in relay

module

PROTECTION FUSESF1 (BATT): 3A/250V (bel 5MF3)F2 (AUX): 1.6A/250V (bel 5MF1.6)F3 (BELL): 3A/250V (bel 5MF3)Install F3 horizontally tosupply 12v nominalregulated power to bell.Install vertically to supply9-18V unregulated to belland terminal 28.

Electronics line (E.L) recommends testþng thesystem at least once a week. Rafer to the testingprocedure found in the installation manualReceiver communication must be tested monthly.

For maximum currentcalculation, add keypadconsumption (approx.60mA per keypad) tý thetotal current drawn fromthe AUX power output.

System BusConnector

12V 7AhBATTERYCharging current700mA max.

Replace the batteryevery 3 - 5 years

AUXILIARY POWER OUTPUTRegulated 12VDC nominal.Fire: Supplies 220mA for 24 hours

Burglary: Supplies 1A for 4 hours(inclýding 100mA to smoke detector.terminasl 24 and 25)

LED SYSTEMSTATUS INDICATOROn = Telephone Tone DetectionOff = System in CommunicationFlashing = DialingFlashing (1 pulse/sec) = Standby

RE

D

BL

AC

K

F1

F3

F2

WH

ITE

GR

EE

N

RE

D

BL

AC

K

Telephone LineConnections

3108/3118/3126LCD Keypad

3106 LED Keypad System Bus

Z1 Z2 Z3 Z4 Z5 Z6 Z7 Z8

Zone Connections

N.C. N.C.

2.2K 2.2K

Typical Endof Line

Resistýr ZoneConnections

(EOLR)Power connection to the unit should be according to the national electrical codefor permanent installation

MicInput

(-)(+)

Siren AudioOutput600mA

AUXPowerOutput

Smoke DetectorOutput

12V nominalmax. 100mA

UnregulatedPower Output

(9-18V)

Transformer15VAC/30VA

Connectto Earth