Owner’sManual

555897 www.masport.com

Please read these instructions carefullybefore assembly.

Keep the instructions in a safe place forfuture use.

Electric Log

7 TonSplitter

2

3

2 5 5 5 6 7 7 8 9101011

4

Parts Schematic..................................................................................................................12

WS7T2300W S6 40% IP54

5 ~ 320 mm520 mm

7 t16 Mpa6.5 L

1060 mm278 mm522 mm

78 kg

5

ELECTRICAL REQUIREMENTS

Connect the main leads to a standard 230V+10% (50Hz+1Hz) electrical supply whichhas protection devices of under-voltage, over-voltage, over-current as well as a residualcurrent device (RCD) which maximum residual current rated at 0.03A.

6

1. Log Pusher2. Work Table3. Wedge4. Lift Handle5. Support Leg6. Log Retaining Plates7. Switch8. Motor9. Pushbutton Box10. Wheels for Minor Moving ONLY.11. Hydraulic Control Lever12. Control Lever Guard13. Bleed Screw14. Oil Drain Bolt w/ Dipstick

12

11

109 8

76

5

4

321

13

14

FAILED TO LOOSEN THE BLEED SCREW WILL KEEP THE SEALED AIR IN HYDRAULICSYSTEM BEING COMPRESSED AFTER BEING DECOMPRESSED. SUCH CONTINUOUSAIR COMPRESSION AND DECOMPRESSION WILL BLOW OUT THE SEALS OF THEHYDRAULIC SYSTEM AND CAUSE PERMANT DAMAGE TO THE LOG SPLITTER.

7

7

15

15DO NOT ADJUST THE MAXPRESSURE LIMITING SCREW !

8

The splitting force and speed are governed by the 2-stage control lever.Push the lever in the 1st stage about half way for faster speed at lesssplitting force to split usual logs; Push the lever in the 2nd stage all wayfor maximum splitting force at slower speed to split particularly hard andseasoned logs. These stages can be shifted by simply raising and loweringthe lever.

9

400

8

10

11

some

PA

RT

S S

CH

EM

AT

IC

12