GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 1g GE imagination at work

imagination at workGE Consumer & Industrial Training Team Feb 2008g

GE Profile Bottom Mount DualDrawer Refrigerator

PGCS1NFXSS Non-Dispenser Series PGCS1PJXSS Dispenser SeriesPGSS5NFXSS Non-Dispenser SeriesPGSS5PJXSS Dispenser Series

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 2g GE imagination at work

Similar to Profile Bottom Freezer but with:• Bowed Doors & Drawers• 2 Freezer Drawers • Hydroformed Handles• Stainless Steel Models only• Dispenser & Non-dispenser Models• Center Mullion with Heater• LED modular lighting in fresh foodsection on dispenser models only

• Icemaker/Ice storage in the BottomBasket

• Icemaker Cover & new Ice Level Switch• Automatic QuickIce Function• Non-Energy Star Rated

Features

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 3g GE imagination at work

Demo Mode

• To enter Demo, press & hold HOME & HELP for 3 seconds.• To exit, repeat the above – disconnecting power will NOT exit Demo.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 4g GE imagination at work

Room Ambient Thermistor

• Main Board uses data from Ambient Thermistor torecalculate target temperatures & results in proper foodstorage under adverse environmental conditions.

• No adjustments are made if the Ambient Thermistor fails.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 5g GE imagination at work

Humidity Sensor

• Main Board uses data from Humidity Sensor to adjust wattage of mullion heaters.• If Energy Saver is “ON” – main board ignores data from Humidity Sensor & heaterswill be off except Freezer DD Mullion Heater (set to 3.4W).

• Measure ~1 to 3.6VDC between J4-3 & J5-6 to test Sensor (no resistance test).• Measure ~5VDC between J4-3 & J5-5 to test main board output.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 6g GE imagination at work

Freezer Drawers

• New DualDrawer design gives added versatility for food storage & access.• Top Drawer is 1/3 of space & Bottom Drawer is 2/3 of space.

• PGCS1 has approx. 6.1 cubic feet of space.• PGSS5 has approx. 7.5 cubic feet of space.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 7g GE imagination at work

Freezer Upper Drawer Adjustment

• Loosen three 10mm hex head screws.• Remove the pilot 10mm hex head screw.

• Make necessary adjustment & retighten three 10mm hex head screws.• DO NOT replace the pilot 10mm hex head screw.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 8g GE imagination at work

Freezer Upper Drawer Removal

• Loosen top Torx (T30) screw from left side, right side is a T30 shoulder type.• Remove bottom Torx (T30) screw from each side.

• Then lift drawer off rails.

Loosen

Remove

Loosen

Left Hinge

Right Hinge

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 9g GE imagination at work

Freezer Lower Drawer Adjustment

• Loosen the top two & bottom two 10mm hex head screws on each hinge.• Remove the pilot 10mm hex head screw on each hinge.

• Make the necessary adjustments & retighten eight 10mm hex head screws.• DO NOT replace the pilot 10mm hex head screws.

Remove Pilot ScrewLoosen

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 10g GE imagination at work

Freezer Lower Drawer Removal

• Loosen the top 10mm hex head screw on each hinge.• Remove the other four 10mm hex head screws on each hinge.

• DO NOT remove any of the Torx screws in the side rails.• Lift the drawer front up & off the slide assemblies.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 11g GE imagination at work

Automatic QuickIce

• When the IM calls for water, themain control board will turn on theevaporator fan for 2 hours if thecompressor is off.

GE Profile Bottom Mount Dual Drawer Refrigerator (2/4/08)GE CONFIDENTIAL & PROPREITARY INFORMATION - NOT FOR PUBLIC DISCLOSURECopyright 2008 General Electric Company – 3/4/2008 12g GE imagination at work

Ice Level Switch

• The IM Level Switch is there to keep theice from overfilling the basket.

• The IM Feeler Arm is now a back-up forice production.

EMIFilter

Main Board

Neutral Output

OrangeBrownJ11

Neutral InputLine Input

Line Output

Ice MakerIce Level

Switch

Bottom Drawer Frz Light Switch

Brown

Top Drawer Fz Light Switch

Note: both freezer drawers closed & ice bin empty.