Thank you for your purchase of this product. Please read this Quick Start Guide before

using your product.

1.Layout 2.Description of OperationBefore the first use

Please charge the Portable Backup Battery and Charger fully before use. TheLEDs indicate the charge status during charging and light up continuously whencharging is complete.

Using the Portable Backup Battery and Charger

1). Place your Apple Watch in the center of the wireless charging module and make sure that is has been detected by the magnetic field.2). Press the power button on the Portable Backup Battery and Charger fully.3). The charging process will begin.4). USB output for charge other mobile devices.

3. Technical specificationsSize:Weight:Capacity:Input voltage:Operating temperature(surroundings):

117x39.5x24.5mm180g5200mAh5V , 2.1A-20℃ -> +60℃

4.Features1). Charge your Apple Watch anywhere at any time.2). The built-in energy saving circuit prevents the Portable Backup Battery and Charger from autonomously discharging by automatically turning it off after 30s without use.3). The built-in wireless charging module is the same as the module that you received with your Apple Watch. (Original Apple product)4). The Portable Backup Battery and Charger can be used for both the 38mm and 42mm versions of the Apple Watch.5).

6). Intellgent protection,with overcharge protection,overdischarge protection, over current protection,short current protection.

The Portable Backup Battery and Charger works with the Apple Watch series 1 & 2.

5.WarningsPlease take care when using the device.

Keep the device away from children and persons under 18.

This device is not a toy.

Keep the device away from humidity and water.

Do not use the device in areas at risk of explosion or near flammable

materials.

It is strictly prohibited to modify, disassemble or repair the device.

Do not expose the device to extreme heat.

Do not store the device in areas where the temperature exceeds 70℃.

Only use and charge the device in areas with a temperature of between

-20℃ and +60℃.

In rare cases the battery may leak. In this case, keep the fluid away from

the skin or your have any other symptoms, contact a doctor immediately.

When the battery has reached the end of its life, dispose of the device

properly.

2

1. Wireless charging modul2. Power button3. Status LEDs4. Micro-USB Charging port5. USB output for charge other mobile devices

1

3 45

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 18 of the FCC Rules. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.”

Dual Charge Power Bank