Driver Seat Removal and Installation

8112019 Driver Seat Removal and Installation

httpslidepdfcomreaderfulldriver-seat-removal-and-installation 13

501-10-1 501-10-1Seating

REMOVAL AND INSTALLATION

Driver Seat

Special Tool(s)

Seat Belt Bolt Bit (Used for

T50 Head Bolt)501-010 (T77L-2100-A)

Removal

7 Using the special tool remove the safety belt1 Position the driver seat rearward buckle support bolt

2 Remove the driver seat front track-to-floor

bolts

8 Disconnect the safety belt buckle switch

electrical connector

3 Move and tilt the front seats to their highest

and most forward position

4 Depower the SRS For additional information

refer to Supplemental Restraint System (SRS)

Depowering and Repowering in the General

Procedures portion of Section 501-20B

5 Disconnect the power driver seat electrical

connector (if equipped)

6 Remove the safety belt buckle support bolt

cover plug

Copyright 983209 2002 Ford Motor CompanyLast updated 2212004 2003 Explorer Sport Sport Trac 92002



501-10-2 501-10-2Seating

REMOVAL AND INSTALLATION (Continued)

9 Remove the driver seat rear bolt trim covers 3 Connect the safety belt buckle switch electrical

connector

10 Remove the driver seat rear bolts

4 Repower the SRS For additional information

refer to Supplemental Restraint System (SRS)Depowering and Repowering in the General


5 Position the seat rearward

6 Tighten the seat front track-to-floor bolts in

sequence shown

1 Tighten the front inboard bolt

2 Tighten the front outboard bolt

11 CAUTION Use care when handling

the seat and track assembly Dropping the

assembly or sitting on a seat not secured in

the vehicle may result in damaged

components

Remove the driver seat from the vehicle

Installation

1 Position the seat into the vehicle Install all the

seat track-to-floor bolts and hand-tighten them

7 Move and tilt the seat to its highest and most2 Connect the power seat electrical connector (if forward position

equipped)

2003 Explorer Sport Sport Trac 92002



501-10-3 501-10-3Seating


8 Tighten the seat rear track-to-floor bolts in

sequence shown

1 Tighten the rear inboard bolt

2 Tighten the rear outboard bolt

11 Install the safety belt buckle support bolt cover

9 Install the rear track bolt covers

12 Check the active restraint system for correct

operation for additional information refer toSection 501-20A

10 Using the special tool install the safety belt

buckle bolt




501-10-2 501-10-2Seating


9 Remove the driver seat rear bolt trim covers 3 Connect the safety belt buckle switch electrical

connector

10 Remove the driver seat rear bolts

4 Repower the SRS For additional information

refer to Supplemental Restraint System (SRS)Depowering and Repowering in the General


5 Position the seat rearward

6 Tighten the seat front track-to-floor bolts in

sequence shown

1 Tighten the front inboard bolt

2 Tighten the front outboard bolt

11 CAUTION Use care when handling

the seat and track assembly Dropping the

assembly or sitting on a seat not secured in

the vehicle may result in damaged

components

Remove the driver seat from the vehicle

Installation

1 Position the seat into the vehicle Install all the

seat track-to-floor bolts and hand-tighten them

7 Move and tilt the seat to its highest and most2 Connect the power seat electrical connector (if forward position

equipped)




501-10-3 501-10-3Seating



sequence shown








buckle bolt




501-10-3 501-10-3Seating



sequence shown








buckle bolt


Documents

Driver Seat Removal and Installation