Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
DECAL:
ASSEMBLY:
1211 Install the propeller.Connect the elevator push rod as shown. Connect the rudder push rod as shown.109
876 Install the wing with PM3x45mm screws.
Glue the plastic part on the wing.
F4U-01 Fuselage F4U-02 Wing F4U-03 Elevator F4U-04 Vertical Stabilizer
F4U-05 Canopy F4U-06 Landing Gear F4U-08 Push Rod F4U-09 Plastic Parts
F4U-13 Cockpit
DYBH-1000 blade holder type A
F4U-10 Decal
DYB-05 PilotDYP-1020 13*7*3 Propeller
DY-1007 9g Servo
DYR-2001 2.4G Receiver
DYT-2003 5CH Transmitter
DYE-1004 40A ESC
DY-3003 Glue
DY-6015 14.8V 2200mAh25C Battery
BM3720A-KV500Brushless Motor
BM3720A-KV500-ShaftMotor Shaft
DY8953
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
CENTER OF GRAVITY(C.G.)
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENTWingspanLengthFlying WeightWing Area Wing LoadRadio SystemPowerBattery
: 1270mm (50in): 1066mm (45.8in): 1650g (58.3oz): 33dm² : 50g/dm²: 5 Ch TX and 7 Ch RX : Brushless System: LIPO, 2200 mAh, 14.8V
Control Throw Setting Suggestion
Elevator Aileron Rudder
14.8V 2200mAh Li-Po, 25C
(13x7x3)
ESC-40A
ESC-40A
Lithium-polymer Battery
2200mAh 14.8V25C Discharge
Rechargeable CellsUse li-po charger only
MOTOR
SPARE PART LIST:
1 2 3 4
5 Connect the E-retract with the Y wires.
Connect the aileron servos with the Y wires.
85 90 85 90
DY-3004 Servo Horn
Apply glue on the contact area of the left and right wing, then glue them together.
Secure the rear wheel onto the fuselage with a 1.5mm hexangular screwdriver.
Apply glue on the contact area of the horizontal stabilizer and vertical stabilizer, then glue them together.
Glue the scale antenna.
Install the main wing.
F4U-12 Cowl
F4U-14 Motor Mount F4U-15 Screw set
F4U-11 Plastic Tab