Upload
prabuppm
View
226
Download
0
Embed Size (px)
Citation preview
May 3, 2023
Presented by:V. R. Prabu[12 ET 14]M.E-EST
1
DIALOGIC SYSTEM
[ DTMF BASED ROBOT CONTROL METHOD ]
May 3, 2023
INTRODUCTION
2
DTMF Mobile ROBO is a machine that can be controlled with a mobile . In this project, the robot is controlled by a mobile phone that makes a call to the mobile phone attached to the robot.
if any button is pressed, a tone corresponding to the button pressed is heard at the other end of the call. This tone is called "Dual Tone Multiple-Frequency" (DTMF) tone.
May 3, 2023
ABOUT DTMF TONE
3
DTMF uses a combination of two (one low frequency and one high frequency) tones to identify the dialled number or a signal. Eight such frequencies are assigned to the four rows and four columns of a typical push-button type dial (keypad).
This method for control using the DTMF tone generated when the user pushes mobile phone keypad buttons or when connected to a remote mobile system.
May 3, 2023
DIAL PAD
4
May 3, 2023
The major building blocks of this project are:
5
GSM Modem/ Mobile PhoneDTMF DecoderMicrocontroller based Control UnitMotor driver ic.
May 3, 2023
BLOCK DIAGRAM
6
May 3, 2023
OPERATION
7
Receiving a set of command in the form of DTMF tones and performs the necessary actions.
We will be using a dedicated modem/mobile at the receiver module. It send the commands using DTMF tones as per the required actions.
DTMF decoder takes the responsibility of decoding the tones received and perform the corresponding predefined tasks such as move front or back, left or right etc.
The micro controller is pre-programmed and also interfaced with few DC motors in order to move the robot in different directions.
May 3, 2023
PIN DIAGRAM
8
May 3, 2023
BLOCK DIAGRAM OF DTMF IC 8870
9
May 3, 2023
DTMF DATA OUTPUT :
10
May 3, 2023
H – BRIDGE METHOD
11
May 3, 2023
CURRENT FLOW DIRECTION
12
May 3, 2023
L293D CONNECT WITH DC MOTOR
13
May 3, 2023
CONNECTION FROM MOBILE :
14
May 3, 2023
CONNECTION DETAIL
15
May 3, 2023
CONCLUSION
16
In the present project DTMF technology has been used to control the stepper motor at a desired direction which in turn may be used in deferent application areas. As conventional RF wireless system has distance limitation. But in this project working range as large as the coverage area of the service provider. The system developed in this project is very much simple and cost effective. It provides the advantage of robust control.
May 3, 2023
REFERENCE
17
http://www.techopedia.com/definition/26023/dual-tone-multifrequency-dtmf
http://www.webopedia.com/TERM/D/DTMF.htmlhttp://www.genave.com/dtmf.htmhttp://
www.businessdictionary.com/definition/dual-tone-multi-frequency-DTMF.html#ixzz2OFK0q2rS
http://www.electroons.com/8051/electroons/dc_motor_control.html
May 3, 202318
THANK YOU
May 3, 2023
?Queries…
19