Upload
others
View
16
Download
0
Embed Size (px)
Citation preview
DG 25
Dial Indicator & Bore Gauge testing equipment § portable for direct inspection into the workshop § test is performed by comparison with a master gauge § built in the respect of Abbe’s principle § measuring travel 25 mm | 1 inch § verification in compliance to norms
2
Accuracy Is related to the master. As an example masters can be: – Heidenhain probe: 0.5 ÷ 0.2 µm | 0.00002 ÷ 0.000008 " – digital indicator: 1 ÷ 2 µm | 0.00004 ÷ 0.00008 " Lever type indicator – maximum lever length 40 mm | 1.5 " – horizontal mounting diameter 4 mm – mounting diameter with 12º inclination 4 mm
Magnifying glass Help reading dial indicator
Upright position
The DG 25 can be fitted on a vertical stand
3
Fitted carrying-case – magnifying glass – long lever dial indicator mounting device – reduction bushes 8 mm, 10 mm and 3/8 " – bore gauge holder (2 points) – master gauge (optional)
Bore gauge inspection
Computer connection (optional) Gage management and measure software is available to provide a complete solution to the calibration needs. Data acquisition can be manual or automatic in relation to the master model. Automatic tolerance calculation is provided.
Specifications and equipment subject to change without notice.
4
distributed by :
20090 SEGRATE – MILANO – ITALY TEL. 02-2139580 FAX 02-2139595 WWW.MICROREP.IT 010507