Embed Size (px)
Citation preview
EARRINGSDESIGN PROJECT
“GROOVY SCULLS”
2 /5CREATE-YOUR-STYLE.COM
Step 1
60 cm
DESIGN PROJECT EARRINGS “GROOVY SCULLS”
Supplies & Tools
Article Product Group Article No. Amount Size Color Color Code
Beads 5750 2 pcs. 13 mm Crystal Silver Night 2x SINI 2
Crystal Pearls 5810 6 pcs. 3 mm Crystal Dark Grey Pearl 001 617
Crystal Pearls 5810 4 pcs. 3 mm Crystal Iridescent Purple Pearl 001 943
Crystal Pearls 5810 16 pcs. 3 mm Crystal Mystic Black Pearl 001 335
Crystal Pearls 5810 10 pcs. 4 mm Crystal Dark Grey Pearl 001 617
Crystal Pearls 5810 6 pcs. 4 mm Crystal Iridescent Purple Pearl 001 943
Crystal Pearls 5810 34 pcs. 4 mm Crystal Mystic Black Pearl 001 335
Crystal Pearls 5810 4 pcs. 5 mm Crystal Dark Grey Pearl 001 617
Crystal Pearls 5810 4 pcs. 5 mm Crystal Mystic Black Pearl 001 335
Crystal Pearls 5810 2 pcs. 6 mm Crystal Iridescent Purple Pearl 001 943
Crystal Pearls 5810 4 pcs. 6 mm Crystal Mystic Black Pearl 001 335
Swarovski crystals
Supplies2x Ear posts, silver2x Jump rings, 4 mm, silverTwo part adhesive glueWire, silver, 0.8 mm, 60 cm
ToolsDrinking glass, 6 cmFlat nose pliersRound nose pliersRulerSide cutterToothpick
Level of design: BEGINNERSHave also a look at the text instructions at the last page!
STEP 1
Stringing
Wiring
3 /5CREATE-YOUR-STYLE.COM
Glue
2 hrs
STEP 2
Step 3
STEP 3
4 /5CREATE-YOUR-STYLE.COM
STEP 4
Repeat steps 1-4 x1:
5 /5CREATE-YOUR-STYLE.COM
STEP 1: Cut a 60 cm long wire and make a loop at one of the ends of the wire. Form the wire into a circle shape using a drinking glass that is approximately 6cm.
STEP 2: Turn the loop formed on the wire to a 90˚ angle. Start inserting the Swarovski crystals from the material list onto the wire. After you insert the Swarovski Bead art. 5750 Crystal Silver Night 2x, place some glue underneath the bead using a toothpick and let it dry for 2 hours. Proceed with the remaining Swarovski crystals as shown.
STEP 3: Insert the other end of the wire through the loop and turn a loop on this end as well.
STEP 4: Attach the ear post to the top loop of the earring using a 4 mm jump ring. Repeat steps 1–4 to make the second earring.
DESIGN PROJECT EARRINGS “GROOVY SCULLS”
