Total power consumed: 13W* Lumen output: 1100lm White, 1050lm Neutral White, 1000lm Warm White Colour temperature: 6000K White, 4000K Neutral White, 3000K Warm White IP rating: IP44 CRI: 80+ Efficacy: up to 85lm/W Dimmable: Yes Beam angle: 120º Power Supply: AC 185-265V 50-60Hz LED type: Epistar SMD LED 60pcs Average life: 40,000 hrs** Warranty: 3 years (4 years for PLI) Diameter Ø110 mm | Height 42 mm Cut-out: 90 mm Box includes: 1 x LED downlight, dimmable driver with flex & plug Additional options: Silver trim (D13MT-S) * Total power consumed including driver **Life calculated on expected average lifespan www.melec.com.au • MUST BE INSTALLED BY LICENCED ELECTRICIAN • Do not extend low voltage cables from the output of power supply • All components must not be mechanically stressed • Be careful not to damage or destroy conductive paths on the circuit board • Follow all relevant electrical and safety standards (including AS3000) • Correct electrical polarity must be observed as the wrong polarity may destroy the product and is not covered under warranty • Damage by corrosion will not be honoured as a material defect claim. It is the user’s responsibility to provide suitable protection against corrosive agents such as moisture, condensation and other harmful elements. • This product has full compliance with the IC-F rating and therefore can be covered in thermal insulation & be installed up against combustible material safely. M-Elec still recommends that an air gap is left around driver + light to ensure the maximum life span of the product is achieved. Please request test report for more details on IC-F. • For further information including photometrics & dimming range, please visit www.melec.com.au PLEASE NOTE

D13 Multi Installation Guide - melec.com.au · Total power consumed: 13W* Lumen output: 1100lm White, 1050lm Neutral White, 1000lm Warm White Colour temperature: 6000K White, 4000K

Download PDF Report

Upload
truongduong
View
224
Download
2

Embed Size (px)

Citation preview

Total power consumed: 13W*Lumen output: 1100lm White, 1050lm Neutral White, 1000lm Warm White

Colour temperature: 6000K White, 4000K Neutral White, 3000K Warm White

IP rating: IP44CRI: 80+Efficacy: up to 85lm/WDimmable: Yes Beam angle: 120ºPower Supply: AC 185-265V 50-60HzLED type: Epistar SMD LED 60pcsAverage life: 40,000 hrs**Warranty: 3 years (4 years for PLI)Diameter Ø110 mm | Height 42 mm Cut-out: 90 mm

Box includes: 1 x LED downlight, dimmable driver with flex & plugAdditional options: Silver trim (D13MT-S)

* Total power consumed including driver**Life calculated on expected average lifespan www.melec.com.au

• MUST BE INSTALLED BY LICENCED ELECTRICIAN• Do not extend low voltage cables from the output of power supply• All components must not be mechanically stressed• Be careful not to damage or destroy conductive paths on the circuit board• Follow all relevant electrical and safety standards (including AS3000)• Correct electrical polarity must be observed as the wrong polarity may destroy the product and is not covered under warranty• Damage by corrosion will not be honoured as a material defect claim. It is the user’s responsibility to provide suitable protection against corrosive agents such as moisture, condensation and other harmful elements.• This product has full compliance with the IC-F rating and therefore can be covered in thermal insulation & be installed up against combustible material safely. M-Elec still recommends that an air gap is left around driver + light to ensure the maximum life span of the product is achieved. Please request test report for more details on IC-F.• For further information including photometrics & dimming range, please visit www.melec.com.au

PLEASE NOTE