CTE Safety Test

Answer Key

1. The ABC’s of shop safety stand

for what? Answer: Always Be Careful

2. What is the name of the yellow lines on the floor around each machine?

Answer: Safety zone

3. How many people should be inside the

yellow lines per machine?

Answer: 1

4. True or False

Loose clothing can be worn in the shop.

Answer: False

5. True or False

The operator is the only person to turn a

machine on or off.Answer: True

6. What must be worn at all times in the

shop?Answer: Safety glasses

7. True or False

No running, pushing or shoving in the lab or shop.Answer: True

8. All accidents should be reported to

whom? Answer: Mr. LeBaron

9. True or False

All students are responsible for the

safety of themselves.Answer: True

10. True or False

Long hair should be worn in a pony tail.

Answer: true

11. What is the name of this machine?

Answer: Drill Press

12. What is the name of this?

Answer: Chuck key

13. Before turning on this machine remove the

_____ ____.

Answer: Chuck key

14.When must this clamp be used?

Answer: When Drilling something smaller than

your fist

15. True or False

Oily rags should be placed

only in a fire proof garbage can. Answer: True

16. What is the name of this machine?

Answer: Disc Sander

17. Which side of the wheel do you sand your work on when using this

type of machine?

Answer: Down side

18. True or FalseYou can have two people work on this machine at

the same time.

Answer: False

19. True or False

It is OK to talk to somebody while they

are operating a machine.Answer: False

20. What is the name of this machine?

Answer: Belt sander

21. What is the name of this machine?

Answer: Scroll saw

22. True or FalseThe Blade should be

tightened only by hand.

Answer: True

23. True or FalseThis saw is used to cut

small curves.

Answer: True

24. What is the name of this machine?

Answer: Band saw

25. True or FalseThis saw is used only to

make straight cuts.

Answer: False

26. You will not cut yourself if your fingers

never touch the __________ __________.

Answer: Throat Plate

27. The guard on this machine should be how

far above the material you are cutting?

Answer: Less than a Pencil width or ¼ inch

28. True or False

All jewelry can be worn while working

on the machines.

Answer: False

29. What is the name of this hand tool?

Answer: Hammer

30. What is the name of this hand tool?

Answer: Nail Punch or Nail Set

31. What is the name of this hand tool?

Answer: Hand File

32. True or FalseIt is ok to open paint cans

with this tool.

Answer: False

33. What is the name of this hand tool?

Answer: Speed Square

34. What is the name of this hand tool?

Answer: Combination Square

35. True or False

Hardwood comes from trees that stay green all

year long.Answer: False

36. True or False

It’s ok to play with the tape measure.

Answer: False

37. True or False

Sanding with the grain is a good idea.

Answer: True

38. Which grit would sand wood

the smoothest?

100 or 220Answer: 220

39. True or FalseIf you are not familiar

with a machineit would be wise to

ask for instructions.

Answer: True

40. True or False

“Keep your mind on your work” is an

important slogan to machine operators.Answer: True