Designed by B.A. Kissinger | Copyright 2002 St. Nicholas
Center
May be printed for use with non-profit groups making art and
craft projects. For all other uses, please request permission from
[email protected]
Slipper For St. Nicholas Day
Material:Colored 2-mm foam sheet or poster boardColored feltGold
3-D scribble paintConstruction paper (for decorations)12-inch piece
of ribbon Embroidery floss (if you sew on toe area )Craft glue
Equipment:ScissorsTapestry needle (if you sew on toe area)Paper
shaper punch (found in craft stores),
for making quick decorative pieces
Directions:1. Cut sole of slipper out of colored foam or poster
board.2. Use 3-D scribble paint to write Happy St. Nicholas Day on
heel part of foam sole.
Let dry 24 hours.3. Cut toe part of slipper out of felt. 4. Sew
or glue toe part in position on sole. Sew or glue just around edge
of sole, leaving center open.
If you used glue, let dry (the toe part could be held in place
with small clothes pins until dry).5. Decorate toe part with paper
punch cut outs, or another way. Let dry.6. Make 2 small holes in
top of slipper. Thread ribbon through holes, tie into a bow.
www.stnicholascenter.org
Designed by B.A. Kissinger | Copyright 2002 St. Nicholas
Center.
May be printed for use with non-profit groups making art and
craft projects. For all other uses, please request permission from
[email protected]
