THE CASE

The case is the frame into which they are installed the main components of a computer. The houses usually have in their upper or lower housing for the power supply, in the middle of different accommodation to contain storage devices and reading, while at the bottom there are slots that serve as output for the hardware that is use of PCI slots. The motherboard is mounted on the right panel. In front of the case is generally present the power button on and off, accompanied by the reset button that allows you to restart the PC. Some homes are equipped with instruments for measuring the temperature inside the PC or the measurement of the speed of calculation of the processor. Usually the panel that allows the display of these data is located in the upper part of the case.

THE MAIN BOARD

The motherboard or system board is an essential part of a modern personal computer in the form of the main electronic board brings together all the electronic circuitry and interface connections between the various main internal components of the PC. Comprising therefore also the expansion bus and the interfaces to the outside. It is therefore responsible for the transmission and correct timing of many hundreds of different signals, all high-frequency and sensitive to interference, between the processor and internal devices and vice versa. Its successful implementation is therefore a key factor for the performance and reliability of the entire computer.It is composed of a printed circuit on which are welded a series of integrated circuits, and Socket connectors; integrated the most important are the chipset that does most of the work interface between the main components and the expansion bus, the Socket for the processor and the connectors required for assembly of the other components of the PC. The current structure of the system boards of the computer is the result of technological trend that has led to define a system architecture valid, in principle, for all the systems of personal computers or class of power comparable.

HARD DRIVE

A hard drive or fixed disk consists basically of one or more platters in rapid rotation, made of aluminum or glass, coated with ferromagnetic material and by two heads for each disk device is a mass storage that uses one or more magnetic disks for the 'data storage. The inductive heads are fundamental components of the hard disk and used for reading and writing on the disc surface, the data processed by a computer. The hard disk is one of the types of memory devices of mass currently the most widely used. It is in fact present in most computers and in other electronic devices. The hard disk has a serious competitor for a short time, the solid-state drive, which is likely in the future to replace it.

THE GRAPHICS CARD

The graphics card has the purpose of generating an electrical signal in output that can be then sent in input to video to be translated by the latter into an optical signal and visually shown to the user. A typical video card contains an integrated graph that manages a certain amount of RAM. The operation of a video card is very simple. Depending on the type of computer device that can be more or less powerful: the first models of video card could only display text, then, there have been video card capable of displaying graphical output and, more recently, three-dimensional textured models in motion and in real time. These types of cards shall also prepare and edit the image in its internal memory, and the cards can show 2D 3D only with the help of the CPU that must run alone all the necessary calculations.

MEMORY

The main memory (also called memory) lets you temporarily store data during program execution. In memory are handled information. It is an essential part and one of the keys to the success of your computer with the ability to store, in modern electronic systems, large amounts of data well beyond human capabilities. In it are stored archive data and user program instructions usable by the user. A memory can be regarded theoretically as a finite sequence of cells where each cell contains a finite sequence of bits, normally managed in groups of eight such bytes. Therefore the physical space of the memory can be thought of as a sequence of positions, each containing one byte. Each location is identified by a specific memory address, normally expressed by a positive integer. The memory corresponds to what is called RAM (Random Access Memory ie random access memory) and ROM (Read Only Memory that is, read-only memory).

PC ‘S PHYSICAL COMPONENTS