Copyright � Siemens AG 2005 All Rights Reserved Disclaimer of Liabillty

The reproduction, transmission or use of this docu-ment or its contents is not permitted without expresswritten authority. Offenders will be liable for damages.All rights, including rights created by patent grant orregistration of a utility model or design, are reserved.

� Siemens AG 2003Technical data subject to change.

We have checked the contents of this manual foragreement with the hardware and software described.Since deviations cannot be precluded entirely, we can-not guarantee full agreement. However, the data in thismanual are reviewed regularly and any necessary cor-rections included in subsequent editions. Suggestionsfor improvement are welcomed.

Further Processing of SIMATIC Documentation

lf SIMATIC documentation is incorporated in customerrelated documentation and if thisdocumentation is to be processed further, care must be taken to keep the Safety-relatedGuidelines in their original form. In all other cases, the contractual agreements regardinglicense conditions for documentation supplied on data media shall apply.

Supplementary Conditions for Supplying Docurnentation on Data Media

1. The Customer is supplied with the documentation specified in the (this) confirmation oforder (subsequently called ”Documentation”) on the data medium stated therein. The”General License Conditions for Software Products for Automation” shall apply to Do-cumentation as far as no other agreements have been made. Paragraphs 3.1, 3.9 and6.1 of the above-named conditions shall also apply to the Documentation.

2. Regarding the documentation forming the basis for the technical documentation of hismachines equipped with SIMATIC programmable controllers from Siemens and thesoftware described in the Documentation, the Customer is granted for an unlimitedperiod of time the non-exclusive right to partly modify, copy with or without changesand grant the right of use, either on paper or data medium, to third parties as part ofthis technical documentation (subsequently called ”Machine documentation”).

3. The Customer takes the sole responsibility for marketing the unmodified or modifieddocumentation included in the Machine documentation.

4. The Customer shall not remove any copyright statements of Siemens from the Docu-mentation. When modifying the Documentation, however, he shall point out in appro-priate form, such as an additional copyright marking, that the Documentation has beenchanged. The Customer is not entitled to use the trademark SIEMENS and shall re-move the trademark from any section copied from the Documentation. When usingtrademarks of Siemens in the Machine documentation, the customer shall identifythem in appropriate form as trademarks of Siemens AG (for example, by means of thenote “SIMATIC is a registered trademark of Siemens AG”).

Siemens AGBereich Automation and DrivesGeschaeftsgebiet Industrial Automation SystemsPostfach 4848, D– 90327 Nuernberg