1
CONTROL DEVICES 1076 State Route 34 | Hurricane, WV 25526 | 1.877.757.6565 | www.eagleresearchcorp.com | Rev 16_06 Maximizing produc�on is a primary importance to every gas well operator. For that purpose, Eagle Research Corpora�on® has developed a Plunger Li� Control unit. When coupled with a Flow Computer,the Eagle Plunger Li� Control constantly monitors the opera�ng characteris�cs of the system, including casing pressure, tubing pressure and plunger arrivals, while adjus�ng the se�ngs to improve the efficiency of the well. Flow rates, produc�on data, and plunger arrival sta�s�cs, in conjunc�on with tank level monitoring, give the operator a complete picture of well performance. The Solenoid Control Interface (SCI) allows the Eagle XA Series™ products to perform remote control of pressure or flow. Using this device, an exis�ng gas regulator can be converted to remotely control pressure or flow without requiring any process piping modifica�ons. Only some instrument tubing and regulators are required for the interface. The SCI uses low power solenoids modula�ng up to 100 PSIG output loading pressure to operate self-contained or pilot operated pressure regulators. The pneuma�c valve output signal can also be used to control diaphragm actuated valves or posi�oners requiring the typical 3-15 or 6-30 PSIG valve commands. Eagle Research Corpora�on® Process Controller is a standalone PID controller with pneuma�c valve output command. The Process Variable Inputs are Pressure, Temperature, DP, Pulses or an AGA calcula�on of flow. The PID logic is performed electronically. The valve output op�ons are 50 or 100 PSIG. The 50 PSI range covers standard commands like 3-15 or 6-30 PSI. The 100 PSI range is used when loading the spring cage of a pilot or self-contained regulator. The standard solar panel and built-in ba�ery allows con�nued control with no external power. Solenoid Control Process Controller Plunger Li�

Control Devices - Eagle Research Corp.eagleresearchcorp.com/Resources/Literature/Control_Devices.pdf · Eagle Research Corpora on® Process Controller is a standalone PID controller

  • Upload
    others

  • View
    14

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Control Devices - Eagle Research Corp.eagleresearchcorp.com/Resources/Literature/Control_Devices.pdf · Eagle Research Corpora on® Process Controller is a standalone PID controller

CONTROL DEVICES

1076 State Route 34 | Hurricane, WV 25526 | 1.877.757.6565 | www.eagleresearchcorp.com | Rev 16_06

Maximizing produc�on is a primary importance to every gas well operator. For that purpose, Eagle Research Corpora�on® has developed a Plunger Li� Control unit.

When coupled with a Flow Computer,the Eagle Plunger Li� Control constantly monitors the opera�ng characteris�cs of the system, including casing pressure, tubing pressure and plunger arrivals, while adjus�ng the se�ngs to improve the efficiency of the well.

Flow rates, produc�on data, and plunger arrival sta�s�cs, in conjunc�on with tank level monitoring, give the operator a complete picture of well performance.

The Solenoid Control Interface (SCI) allows the Eagle XA Series™ products to perform remote control of pressure or flow.

Using this device, an exis�ng gas regulator can be converted to remotely control pressure or flow without requiring any process piping modifica�ons. Only some instrument tubing and regulators are required for the interface.

The SCI uses low power solenoids modula�ng up to 100 PSIG output loading pressure to operate self-contained or pilot operated pressure regulators. The pneuma�c valve output signal can also be used to control diaphragm actuated valves or posi�oners requiring the typical 3-15 or 6-30 PSIG valve commands.

Eagle Research Corpora�on® Process Controller is a standalone PID controller with pneuma�c valve output command. The Process Variable Inputs are Pressure, Temperature, DP, Pulses or an AGA calcula�on of flow. The PID logic is performed electronically. The valve output op�ons are 50 or 100 PSIG. The 50 PSI range covers standard commands like 3-15 or 6-30 PSI. The 100 PSI range is used when loading the spring cage of a pilot or self-contained regulator. The standard solar panel and built-in ba�ery allows con�nued control with no external power.

Solenoid Control

Process Controller

Plunger Li�