Coneqtec Thumb Kits for New Holland C Series with Extendahoe

Hydraulic Powered Thumbs Manual Fixed Position Thumbs

Dual direction (bidirectional) hydraulic kits are required to operate powered thumbs.

There are three working position pinholes and one storage position on the manual fixed position model.

Coneqtec thumbs are entirely pin-on and do not require any welds or holes drilled into the dipper stick. This allows users to easily install, remove and transfer the thumbs to other C Series backhoe loaders. The clamps hinge on the bucket pin so they’re lined up perfectly with the bucket every time. Clamps can be ordered with smooth edges or with teeth. Hydraulic powered and manual fixed position models are available.

TLBs without existing auxiliary hydraulics

TLBs with factory single direction auxiliary hydraulics

Other Options: Guards, Lights, Fenders & Heaters

Single Direction Kitto run a hammer or compaction plate.

Dual/Single Direction Combination Kitcapable of running a thumb or auger, as well as your single direction attachments.

These kits contain everything you need to add the auxiliary hydraulics – valve, hoses, boom tubes, and electrical. The valve will include a 6-position flow selector (installed next to the left hand door) that will allow you to easily choose from 6 preset flow settings (8, 13, 18, 22, 26, 30 GPM) to adjust the flow provided to attachments without the need for tools.

Conversion Single to Dual/Single Direction Kitfor those that need the ability to run dual direction attachments as well. This kit will use the existing factory single direction valve, boom tubes and swing tower hoses. The conversion kit includes a dual direction valve add-on (without 6-position flow selector), hoses that run underneath the machine, and all necessary electrical components to complete the kit.

Pin-OnThumb Kits

for New Holland