Upload
alisa-mcclure
View
523
Download
10
Embed Size (px)
Citation preview
Connect to a Controller &
Update the OS
Component Check
RS232 Cable
-Supplied
MJ10-22-CS35 (USB to Serial converter)-Additional
MJ10-22-CS25 (RJ11 to DB9 converter)-Supplied
Check physical connections
• Jumpers are set for RS232 communication
Port 1
• Check part numbers -Serial cable MJ10-22-
CS25 -USB adapter MJ10-22-
CS35
• Serial cable plugged into Port 1 on PLC
USB programming cable
• Some of our units can be programmed through a Mini-USB programming port- (If equipped, IE- V1210/V1040/V570)
• No other hardware is required for USB connection
Note that COM port 1 function is suspended when the USB port is physically connected to the PC.
USB Driver
USB port supports only OS and project download.
• If requested to use Windows Update--do not accept this option; "Skip obtaining driver software from Windows Update".
• Install only the driver provided by VisiLogic.• The USB cable must be disconnected during
the installation.
Driver Check
Check software settings
• Baud rate
- Standard-57600 baud
- Enhanced-115200 baud
• Select “Get OPLC Info” button to check/confirm PLC
• Check Device Manager to ensure -Port has no errors or warnings (PC port is confirmed here)
Check for O/S updates
• Requires connection to internet.
• Updates automatically if required.
Has a new O/S been released?
You will receive one of 2 messages.
-Up to date.
-Updating files
Check & perform an O/S update
Updating an OS
• The System Upgrade Wizard will guide you through the update of the OS
O/S Updating
– A Progress Bar will show you the operations and current steps in progress
Finish Update of O/S
• Successful OS Update
O/S Update Not Required
Thank you !