Commissioning Instruction

VARIODYN D1 VARIODYN D1 Comprio

GB

798664.HO.GB0

G 210122 Technical changes reserved!

09.2013 / AB

2013 Honeywell International Inc.

Commissioning Instruction VARIODYN D1 / VARIODYN D1 Comprio

Intended purpose This product may only be used for the applications outlined in the catalogue and in the technical description and only in combination with the recommended and approved external devices and components. Warning

In order to ensure correct and safe operation of the product, it must be transported, stored, installed and assembled properly and operated carefully. Safety-related information for the user

This manual includes all the information required for proper use of the products described in it.

The term qualified personnel in the context of safety remarks in this manual or on the product refers to

project planning personnel who are familiar with the safety guidelines of voice alarm systems.

trained service engineers who are familiar with the components of voice alarm systems and the operating information contained in this manual.

trained installation and service personnel who have the necessary qualifications for carrying out repairs on such voice alarm systems and emergency audio warning systems and who are authorised to set up, ground and label electrical circuits and devices/systems in line with the corresponding safety standards.

Warning instructions

The following information is given in the interest of your personal safety and to prevent damage to the product described in the manual and all equipment connected to it.

Safety-related information and warnings for the prevention of hazards to the life and health of users and maintenance staff as well as damage to the equipment are highlighted in the manual by the pictograms defined here. The pictograms have the following meanings within the context of the manual:

Means that there is a danger of serious injury, death or considerable material damage if the respective safety measures are not taken.

Important information about the product or a specific part of the manual which should be read with particular attention.

Dismantling

In accordance with Directive 2002/96/EC (WEEE), the manufacturer will accept the return of the electrical and electronic device for proper disposal after dismantling!

2 FB 798664.HO.GB0 / 09.13

Commissioning Instruction VARIODYN D1 / VARIODYN D1 Comprio

1 General / Application ................................................................................................................................................ 5

1.1 Associated Documents ............................................................................................................................................ 5 2 Overview ................................................................................................................................................................... 6

2.1 VARIODYN D1 ....................................................................................................................................................... 7 2.2 VARIODYN D1 Comprio ....................................................................................................................................... 7

3 Preparation for Commissioning ............................................................................................................................... 8 3.1 Software .................................................................................................................................................................... 8 3.2 System Requirements ............................................................................................................................................. 8 3.3 VARIODYN D1 Designer Software Installation .................................................................................................... 9

4 Commissioning ....................................................................................................................................................... 11 4.1 Preparations ........................................................................................................................................................... 11 4.2 Configuring IP Address .......................................................................................................................................... 12 4.3 Loading Files into the Internal Audio Memory ...................................................................................................... 13

4.3.1 Converting Audio Files to the VARIODYN D1 Format ............................................................... 13 4.3.2 Uploading Audio Files to the control unit ..................................................................................... 14 4.3.3 Displaying Audio Files in the control unit ..................................................................................... 15 4.3.4 Commissioning the SCU (if present) ........................................................................................... 16

4.4 Configuring the SCU IP Address (if delivered with a default IP address) .......................................................... 16 5 Configuration .......................................................................................................................................................... 17

5.1 The Program Interface ........................................................................................................................................... 17 5.2 Menu Navigation .................................................................................................................................................... 20

5.2.1 File ............................................................................................................................................... 20 5.2.2 Project .......................................................................................................................................... 21 5.2.3 View ............................................................................................................................................. 24 5.2.4 Language ..................................................................................................................................... 26 5.2.5 Window ........................................................................................................................................ 26

5.3 Hardware Configuration ......................................................................................................................................... 27 5.3.1 Control unit DOM or Comprio ...................................................................................................... 28 5.3.2 System Communication Unit (SCU) ............................................................................................ 30 5.3.3 Call Station (DCS) ....................................................................................................................... 31 5.3.4 Digital Key Module (DKM) ........................................................................................................... 32 5.3.5 Universal Interface Module (UIM) ................................................................................................ 32 5.3.6 Contact Interface Module (CIM)................................................................................................... 33 5.3.7 Time Control Module (TCM) ........................................................................................................ 33 5.3.8 Network Time Protocol Server (NTP Server) .............................................................................. 34 5.3.9 Speaker Line ................................................................................................................................ 35 5.3.10 Loudspeaker ring loop (Loop) ...................................................................................................... 36 5.3.11 Main Switching Unit (MSU) .......................................................................................................... 37 5.3.12 Rack ............................................................................................................................................. 37 5.3.13 Amplifier (PA) ............................................................................................................................... 37 5.3.14 Replacement Amplifiers ............................................................................................................... 38 5.3.15 FACP Connection ........................................................................................................................ 40 5.3.16 View Control Modul (VCM) .......................................................................................................... 40 5.3.17 Host-object ................................................................................................................................... 40 5.3.18 Text Object................................................................................................................................... 40

5.4 Basic Functionality ................................................................................................................................................. 41 5.4.1 General Information ..................................................................................................................... 41 5.4.2 Target Group ..........................................................