2
Dont write .pdf and .dox See if the reports should be there after the contents and before the list of figures Plan of the GA drawing to be included in the introduction of the main report, Description of superstructure is the figure from the CSOP of the deck slab Show the elevation fo the transverse section Put the idealization to the modelling part. Keep text as justified, Insert drawings that Rikke has forwarded in the description of the foundation. Add extra figure to show the springs Show calculation for spring stiffness variation for surface springs Present in the form a table for the support conditions and critical moments Use Stiff springs and soft springs. Poisons ration for cracked concrete ??????? Load combinations: Refer the table as per Danish Annex, Give numbers for the earth-pressure Static Check –not required for now Temperature and settlement should be moved under deformation load. Check the char load combination for dyanamic factor. Check again……. Sketch for reinforcement instead of the table.

Comments by KPTH on Main Report

Embed Size (px)

DESCRIPTION

Comments by KPTH on Main Report

Citation preview

Dont write .pdf and .doxSee if the reports should be there after the contents and before the list of figuresPlan of the GA drawing to be included in the introduction of the main report,Description of superstructure is the figure from the CSOP of the deck slabShow the elevation fo the transverse sectionPut the idealization to the modelling part.Keep text as justified,Insert drawings that Rikke has forwarded in the description of the foundation.Add extra figure to show the springsShow calculation for spring stiffness variation for surface springsPresent in the form a table for the support conditions and critical moments Use Stiff springs and soft springs.Poisons ration for cracked concrete ???????Load combinations:Refer the table as per Danish Annex,Give numbers for the earth-pressureStatic Check not required for nowTemperature and settlement should be moved under deformation load.Check the char load combination for dyanamic factor. Check again.Sketch for reinforcement instead of the table.