Colloidal Silver Generator How to Make

 Prelude: Make Colloidal Silver at Home 

This is the new device Which I use lately, and I'm Satisfied with it in all respects. It is one of the Selbstbau-Realization Project. I have changed it a little bit. The original device operated with a 5mA current electrode. In my opinion for it's a lot. I have modified the power generator, so now the electrode current is 1.0 mA. Furthermore, I have added the polarity changer, as it is a must.

Colloidal silver generator circuit and the deviceLet's see! It is also working with the Higher Than Usual voltage, but bottom more efficient. Since in an idle (unloaded) position the voltage can reach 60V on the silver electrodes, we particularly Should Be Cautious. This exceeds extra-low voltage, so it feb not in marketing, small children and Should not Be allowed to enter anywhere near!The designer chose an unusual way in order to in- crease the voltage. The transformer TR1, operating in reverse mode, TRANSFORMS up the output voltage of an alternative provider 12V AC adapter. We use only one half of the 2 x 12 and 2 x 110-volt transformer. There is one transil bidirectional diode (transient suppressor) Both in the primary and secondary circuits, Which are Responsible for keeping the peak voltage at bay. Additional limiting element voltage is the zener diode ZD51 post rectification. This is a deliberately frivolous Followed by filtering with the help of the 1N4003 diode and 22mF condenser. Thus, the Pulsating DC gets to the silver electrodes, Which is Likely to Become Beneficial for the device.

The Waveform Measured on the silver electrodes at the beginning of colloidal silver production

 The lower half of the schematic illustrates the polarity switch relay thathas been actualized with the 555 timer. With the help of the applique components, it switches polarity symmetrically in about one minute. Under 1.5 hours I create 3dl 10 ppm dense (In My Opinion) quality colloidal silver with it. This density is Sufficient. The more is not better! The Resulting solution is less color, Tasteless. It Should Be like that. Okay, the Slight metallic taste can put on - eventually there is silver

in it. On the electrodes and on the surface of the colloidal silver precipitation is infinitesimally low. Measurement results:

For the evaluation we need to know the Following:

I use 12 cm long; 1.63 mm in diameter, 99.99% pure silver wire electrodes German, Which have the length of subservient (That is immersed in distilled water) to 80 mm.

Between the electrodes distance is 25 mm

I heat the distilled water During the production of colloidal silver. 220V, 50W-efficient halogen bulb is like the radiator, the same as what they'll use to light with cupboards. As you can seen on the pictures, above the light bulb, approximately 8 mm away there is a 5 mm thick iron plate - this is the "chock". This piece of iron is hot When it functions, but the distilled water in the glass is only around 40 ° C. It Reaches under this Operating temperature 45 to 60 minutes, the time I wait to switch on the colloidal silver-producing circuit after switching on the heating Earlier. Heat Transfer Increases significantly - the Liquid Temperature Can

Be Increased to 50 degrees - Slightly if I lubricated the bottom of the jar with silicone grease. The heating in the Requirement quality as well, BECAUSE In The Meantime, it can solve the thermal mixing of the solution.

 If this guide was Useful to you, please do not forget to "like"! Thank you.

Olvasd tovább: http://sansz.net/colloidal-silver/how-to-make-colloidal-silver-generator/#ixzz3I5TFIexR