8. Connect tubing and fill according to pump User Manual.

TO INSERT SITE AND CONNECT TUBING SET

1. Wash and dry hands thoroughly. 2. Prepare site, allow to dry. 3. Twist cap to remove.

4. Inspect device for adhesive and insertion needle.

5. Press firmly until you hear a click; hold for 5 seconds; pull straight off.

6. Verify needle retracted.

7. Press to secure adhesive. 9. Pinch site connector arms inward and slide fully open.

10. Attach tubing to site, according to the most adequate position. The Cleo® 90 has eight possible positions.

11. Close the connector, an audible click confirms closure.

12. Fill cannula with medication.

• The 6 mm cannula has 0.002 mL priming volume.

• The 9 mm cannula has 0.003 mL priming volume.

DISCONNECTIONOpen the connector by pinching the site connector arms inwards and sliding fully open.

Change the catheter per your facility policy and procedures.

WITHDRAWAL OF THE INJECTION SITE CHANGE OF THE CLEO® 90 CATHETER

Please see Instructions for Use for a complete list of the indications, contraindications, warnings and precautions.

Find your local contact information at: www.smiths-medical.com/customer-support Smiths Medical is part of the global technology business Smiths Group plc. Please see the Instructions for Use/Operator’s Manual for a complete listing of the indications, contraindications, warnings and precautions. Cleo and the Smiths Medical design mark are trademarks of Smiths Medical. The symbol ® indicates the trademark is registered in the U.S. Patent and Trademark Office and certain other countries. All other names and marks mentioned are the trademarks or service marks of their respective owners. Product referenced is CE-marked. ©2018 Smiths Medical. All rights reserved. IN193874EN-012018

Smiths Medical ASD, Inc. 6000 Nathan Lane North Minneapolis, MN 55442, USA Tel: 1-614-210-7300Toll-Free USA: 1-800-258-5361

PRODUCT(S) DESCRIBED MAY NOT BE LICENSED OR AVAILABLE FOR SALE IN CANADA AND OTHER COUNTRIESMMSPCA-0046

Cleo® 90 Infusion Set Training Guide