Upload
others
View
19
Download
0
Embed Size (px)
Citation preview
Take into consideration before you install:• Due to the size and mass of this product it
is important that the wall mounted system is safely installed according to these installation instructions.
• Make sure that the type of wall is capable of supporting the system and only use screws that are suitable for that type of wall. The lag screws that come with the product are ONLY suitable for installation into a single wood stud.
• The wall mounted system must be installed by qualified personnel, in accordance with state and local building regulations.
Cisco DX80 VESA Mount Adapter and Wall Bracket
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2
The VESA mount adapter is compatible with VESA 100 × 100 and 75 × 75 mounting patterns.
The VESA adapter can be used with third party VESA mounts, such as a VESA arm. Follow steps 1 - 2 to mount the VESA adapter.
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2
Wall Mounting
1
2
3
5
Place the DX80 on a clean, flat surface.
Make sure not to exert force on the camera, or the screen, that may damage your system.
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2
Use four screws to mount on two beams, concrete and plaster walls. Use two screws to mount on one beam.
4
VESA Adapter
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2
78-100445-01 A0 | FEBRUAR 2015 © 2015 Cisco Systems, Inc. All rights reserved.
x4 x4
0.25 eller 0.75x2
x4 x2x2
x2