Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Chip-Type Ceramic Secondary Battery
・
LiCoO2 ceramic plate with high-speedLi ion conductivity by crystal orientation.
The battery is packaged with all-ceramic stackedmonolithic body with a minimal amount of liquid electrolyte.
Smart card IoT module Bluetoothsolar powered watch
On-boardpower source
Oriented electrode plate
Organicelectrolyte
Ultra-thin 0.45mm thick, bendable batterythat can be embedded in IC cards, and similar products.
・Coin-shaped battery (thickness of 1mm or more) that can be mounted on a circuit boardusing reflow soldering・Can accommodate hot lamination in card production.
・Constant voltage charging is possible, which eliminates the need for charger IC.
・High-speed charging is possible fromnon-contact card readers.
Negative electrode
Technology
+ terminal
- terminal
EnerCera®Pouch EnerCera®Coin
Ultra-compact Lithium-ion rechargeable battery suitable to be used for power source for loT devices, etc. Proprietary crystal orientation ceramic plate is applied to the electrode to achieve a smaller, thinner, high capacity, low internal resistance, and high heat resistance. The battery can output large current, up to several 100mA, necessary for operating ICs, sensors and wireless communication.
◆Oriented Electrode Plate
◆Semi-Solid State Battery (EnerCera Coin)
EnerCera®Series
https://www.ngk-insulators.com○c 2020 NGK INSULATORS, LTD.
Appearance
ET1210C-R ET2016C-R ET920C ET1616CET1210C-H ET2016C-HUnder development
Φ12 Φ20 Φ12 Φ20 Φ9 Φ16
1 1.6 1 1.6 2 1.6
5 25 4 20 5 24
2.3
OK
20 8 25 10 20 6
25 60 20 50 25 80
-40~60℃ -40~85℃ -40~60℃
Reflow soldering Battery holder
High Capacity High Heat Resistance High Power
Dimensions:Diameter (mm)
Height (mm)
Nominal Capacity (mAh)
Nominal Voltage (V)
Constant Voltage Charging
Internal Resistance (Ω)
Peak Discharge Current (mA)
Operating Temp.(recommended)
Mounting Method
Features
Dimensions (mm)
ET271704P-HEC382704P-HEC382704P-CEC382504P-P
27x1738x2738x2738x25
0.45
5202720
2.33.8
OK
5431
100125170500
Conforming to ISO14443-1 standard. No deterioration after bending and torsion tests
-40~60℃0~45℃
135℃ (Hot Lamination is available)
(10min@80%Capacity)
80℃ (only Cold Lamination is available)
Fast charging(High heat resistance)Hot process availableHigh capacityHigh power
*1 Voltage drop<0.5V@1sec
Thickness (mm)
Nominal Capacity (mAh)
Nominal Voltage (V)
CV Charging (charging time)
Internal Resistance (Ω)
Peak Discharge Current (mA) *1
*1
Bendability
Operating Temp. (recommended)
Heatproof Temp.
Features
Contents may be changed without notice
ET1210C-HET2016C-H
Appearance
EnerCera®Coin
EnerCera®Pouch
-(CC-CV)
https://www.ngk-insulators.com○c 2020 NGK INSULATORS, LTD.