3
8/10/2019 Chapter – 7, Solution and Suspension http://slidepdf.com/reader/full/chapter-7-solution-and-suspension 1/3 CHAPTER 7, SOLUTION AND SUSPENSION SOLUTION A homogeneous mixture of different chemical substances which has uniform chemical composition throughout and shows uniform physical properties is called solution. For example dissolve a small amount of Copper Sulphate in water the water will become blue. If this blue liquid is filtered, it will pass through the filter paper without leaving any solid. The mixture thus prepared is called a solution. BINARY SOLUTION A solution which is formed by mixing two substances is called binary solution. For example, solution of glucose and water is a binary solution. SOLUTE The component of a binary solution which is in lesser amount is called solute. For example in copper Sulphate solution, Copper Sulphate is solute. SOLVENT The component of a binary solution which is in greater amount is called solvent. For example in copper Sulphate solution, water is solvent. SATURATED SOLUTION A solution in which maximum amount of a solute has been dissolved at a particular temperature and in which the dissolved form of solute is at equilibrium with its undissolved form is called saturated solution. UNSATURATED SOLUTION Solution which can dissolve further amount of a solute at a [particular temperature is called an unsaturated solution. SUPERSATURATED SOLUTION The solution which contains even more amount of solute required to prepare saturated solution is called super saturated solution. The hot saturated solution of compound like sodium thiosulphate does not crystallize its solute if cooled slowly without disturbance. Such a solution is called supersaturated solution. DILUTE SOLUTION A solution which contains small amount of a solute as compared to t he solvent is called dilute solution. CONCENTRATED SOLUTION A solution which contains excess amount of a solute as compared to that of a solvent is called a concentrated solution. CONCENTRATED SOLUTION The amount of solute present in given quantity of solvent is called concentration of solution. The concentration of a solution can be expressed in many ways depending upon the amount o solute and solvent present in it. CONCENTRATION OF SOLUTION The amount of solute present in given quantity of solvent is called concentration of solution. The concentration of a solution can be expressed in many ways depending upon the amount of solute and solvent present in it. PERCENTAGE BY MASS The percentage of solute by mass is the mass of solute present in hundred part of the solution. For example 5% hydrogen peroxide solution by mass means that 5g hydrogen peroxide are dissolved in 95g of water to give 100g of solution. Percentage of Mass = (Mass of Solute/Mass of Solution) x 100

Chapter – 7, Solution and Suspension

  • Upload
    dilzub

  • View
    226

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Chapter – 7, Solution and Suspension

8/10/2019 Chapter – 7, Solution and Suspension

http://slidepdf.com/reader/full/chapter-7-solution-and-suspension 1/3

CHAPTER – 7, SOLUTION AND SUSPENSION

SOLUTION

A homogeneous mixture of different chemical substances which has uniform chemical composition throughout andshows uniform physical properties is called solution. For example dissolve a small amount of Copper Sulphate in waterthe water will become blue. If this blue liquid is filtered, it will pass through the filter paper without leaving any solid.The mixture thus prepared is called a solution.

BINARY SOLUTION

A solution which is formed by mixing two substances is called binary solution. For example, solution of glucose andwater is a binary solution.

SOLUTE

The component of a binary solution which is in lesser amount is called solute. For example in copper Sulphate solution,Copper Sulphate is solute.

SOLVENT

The component of a binary solution which is in greater amount is called solvent. For example in copper Sulphatesolution, water is solvent.

SATURATED SOLUTION

A solution in which maximum amount of a solute has been dissolved at a particular temperature and in which thedissolved form of solute is at equilibrium with its undissolved form is called saturated solution.

UNSATURATED SOLUTION

Solution which can dissolve further amount of a solute at a [particular temperature is called an unsaturated solution.

SUPERSATURATED SOLUTION

The solution which contains even more amount of solute required to prepare saturated solution is called supersaturated solution. The hot saturated solution of compound like sodium thiosulphate does not crystallize its solute ifcooled slowly without disturbance. Such a solution is called supersaturated solution.

DILUTE SOLUTION

A solution which contains small amount of a solute as compared to the solvent is called dilute solution.

CONCENTRATED SOLUTION

A solution which contains excess amount of a solute as compared to that of a solvent is called a concentrated solution.

CONCENTRATED SOLUTION

The amount of solute present in given quantity of solvent is called concentration of solution. The concentration of asolution can be expressed in many ways depending upon the amount o solute and solvent present in it.

CONCENTRATION OF SOLUTION

The amount of solute present in given quantity of solvent is called concentration of solution. The concentration of asolution can be expressed in many ways depending upon the amount of solute and solvent present in it.

PERCENTAGE BY MASS

The percentage of solute by mass is the mass of solute present in hundred part of the solution. For example 5%hydrogen peroxide solution by mass means that 5g hydrogen peroxide are dissolved in 95g of water to give 100g ofsolution.

Percentage of Mass = (Mass of Solute/Mass of Solution) x 100

Page 2: Chapter – 7, Solution and Suspension

8/10/2019 Chapter – 7, Solution and Suspension

http://slidepdf.com/reader/full/chapter-7-solution-and-suspension 2/3

PERCENTAGE BY VOLUME

The concentration unit expresses the volume of solute present in 100cm3 of solution. For example 15% solution ofalcohol by volume will mean that 15cm3 alcohols are present in 100cm3 of solution. (Here 3 represents cube)

Percentage by Volume = (Volume of Solute/Volume of Solution) x 100

MOLAR SOLUTION

The solution that contains one mole of solute in 1dm3 of solution is called a molar solution. The concentration of thissolution is expressed as M.

MOLARITY

Molarity of a solution is the number of moles of solute present in 1dm3 of the solution. It is expressed as M.

M = Number of Moles of Solute/Volume of Solution in dm3

or

M = (Mass of solute/Molecular Mass) x (1/ Volume of Solution in dm3)

CRYSTALLIZATION

The process in which crystal separates from saturated solution on cooling is called crystallization. It is a useful processbecause it can be used to purify the impure solid compounds. It can also be used to separate a mixture of solids.

HYDRATION

The ions surrounded by solvent molecules in solution are called solvated ions. If water is a solvent these ions are calledhydrated ions.

SUSPENSION

A suspension in such a mixture in which solute particles do not dissolved in solvent and if filtrated its particles do notpass through the pores of filter paper.

COLLOIDAL SOLUTION

In a colloidal solution the solute particles are slightly bigger than those present in a true solution but not big enough toseen with naked eye.

STANDARD SOLUTION

A solution whose molarity (strength) is known is called Standard Solution.

TRUE SOLUTION

A True Solution is such a mixture in which solute particles are completely homogenized in the solvent for examplesolution of sodium chloride or copper Sulphate in water.

SOLUBILITY

Solubility o a solute in a particular solvent is defined as the amount of solute in grams, which can dissolve in 100g of

the solvent at a particular temperature to give a saturated solution.

or

The amount of a solute in gram moles, which can dissolve in one kilogram of the solvent at a particular temperature,to give a saturated solution.

Page 3: Chapter – 7, Solution and Suspension

8/10/2019 Chapter – 7, Solution and Suspension

http://slidepdf.com/reader/full/chapter-7-solution-and-suspension 3/3

FACTORS AFFECTING THE SOLUBILITY

Effect of Solvent

Similar solvents dissolve similar solutes, i.e. if the chemical structure and the electrical properties such as dipolemoment of solute and solvent are similar, the solubility will increase. If there is dissimilarity in properties, then eitherthe solute will not dissolve or there will be very little solubility.

Effect of Solute

Different solutes have different solubility’s in a par ticular solvent e.g. if the saturated solutions of table sugar andsodium chloride are prepared, it is found that the concentration of sodium chloride solution is 5.3 molar while that ofsugar solution is 3.8 molar. In other words, the solubility of sodium chloride in water is far greater than that of sugar.This is due to the fact that the attraction of sodium (Na+ and chloride (Cl-) ions with water is greater than that of sugarmolecules with water.

Effect of Temperature

Change in temperature has different effects on the solubility of different compounds. Usually the solubility increasewith the increase in temperature but it cannot be taken as a general rule. The solubility of compounds like lithiumcarbonate, calcium chromate decreases with the increase in temperature. The solubility of gases in water alsodecreases with the increase in temperature. On the other hand, there are a large number of compounds whosesolubility in water increase with the increase in temperature e.g. sodium nitrate, silver nitrate, Potassium chloride etc.the solubility of sodium chloride in water does not increase appreciably with the increase in temperature.