Upload
nanbanda-nanbanda
View
213
Download
0
Embed Size (px)
DESCRIPTION
bvgftryuiolkjhn
Citation preview
12.3 ASME VIII section UCS-66: impact testexemption familiarization questions
Q1. ASME VIII section UCS-66A stationary vessel is made from 3 in thick SA516 GR70 platethat has been normalized. The MDMT is 30 8F at 500 psig. Doesthis material require impact testing?
(a) No &(b) Yes &(c) Only if the vessel ID is less than 36 in &(d) Only if the vessel ID is greater than 36 in &
Q2. ASME VIII section UCS-66A vessel constructed of curve B material is to be patch-platedwith a llet welded patch of the same material as the shell. Thestress ratio is calculated as 0.64. The patch and vessel are 0.622 inthick with zero corrosion allowance. The MDMT is 15 8F.From the information given, does the repair require impacttesting of the repair procedure?
(a) Yes &(b) No &(c) Yes, if optional PWHT is done &(d) There is insufcient information in the question to
decide &
Q3. ASME VIII section UCS-66A 1.125 in thick lap-welded patch is of SA-515 Gr 70 P1material. The vessel nameplate shows MDMT as 50 8F HT,denoting that the patch has been voluntarily heat-treated. Thestress ratio is 1. From the information given, does the repairrequire impact testing of the repair procedure?
(a) Yes &(b) No &(c) Only if the optional PWHT is actually done &(d) There is insufcient information in the question to
decide &
Impact Testing
211