Embed Size (px)
DESCRIPTION
Antonio Conde, PH-CMX. CHAMBER MECHANICS & MECHANICAL INTEGRATION. GE1/1 CHAMBER & SC. MASS : 9,2 Kg. Recent 20mm elongation In this direction (HV Div.). New position of HV Divider. New Cooling Pipe and copper Sheets. DC-DC Converters. Electronic GBT’s. - PowerPoint PPT Presentation
Citation preview
III GEM WORKSHOP 1
CHAMBER MECHANICS & MECHANICAL INTEGRATION
18/04/2012
Antonio Conde, PH-CMX
III GEM WORKSHOP 2
GE1/1 CHAMBER & SC
18/04/2012
III GEM WORKSHOP 318/04/2012
MASS : 9,2 Kg
Recent 20mm elongationIn this direction (HV Div.)
III GEM WORKSHOP 418/04/2012
III GEM WORKSHOP 518/04/2012
New position of HV DividerNew Cooling Pipe and copper Sheets
DC-DC Converters
Electronic GBT’s
III GEM WORKSHOP 618/04/2012
The cover is a unique part now (before was shield+chimney)
VFAT Connectors & Hybridsnow rotated 90°
III GEM WORKSHOP 718/04/2012
III GEM WORKSHOP 818/04/2012
III GEM WORKSHOP 918/04/2012
GAP-PAD LARGER THAN CHIP
III GEM WORKSHOP 1018/04/2012
COVER, FRAME & DRIFT EXTENDED20mm DUE TO NEW LOCATION OF HVDIVIDER
III GEM WORKSHOP 1118/04/2012
Pivots 20mm now shorter due to elongation of the Frame(Surface treatment for sliding needed)
STRAIGTH SC
PIVOTING SC
(Mass: 18,8 Kg)
(Mass: 18,7 Kg)
ADDING PIVOTS & FEET TO FORM SC
III GEM WORKSHOP 1218/04/2012
STRAIGTH SC
PIVOTING SC
PATCH-PANELS
III GEM WORKSHOP 1318/04/2012
(lack cooling and gap-pad; cover unique part; some screws disappeared)
TO BE UPDATED
III GEM WORKSHOP 14
GE1/1 INTEGRATION
18/04/2012
III GEM WORKSHOP 1518/04/2012
BACK-FLANGE
III GEM WORKSHOP 1618/04/2012
DETECTOR ENVELOPE
36 SC PER SIDE(18 STRAIGTH+18 PIVOTING)
III GEM WORKSHOP 1718/04/2012
III GEM WORKSHOP 1818/04/2012
QUESTIONS :
- INITIAL FLATNESS OF THE BACK-FLANGE ?
- BACK-FLANGE MAGNETIC DEFORMATION ?
- ARE THERE NON FORESEEN CABLES OR PIPES ?
III GEM WORKSHOP 1918/04/2012
REDUCING STACKING HEIGHT IN 18mm TO BE STUDIED
III GEM WORKSHOP 2018/04/2012
III GEM WORKSHOP 2118/04/2012
III GEM WORKSHOP 22
GE2/1 INTEGRATION
18/04/2012
III GEM WORKSHOP 2318/04/2012
WIDTH OF THE ENVELOPE : 150mm
III GEM WORKSHOP 2418/04/2012
RE2/3RE2/2
GE2/1
III GEM WORKSHOP 2518/04/2012
- 2 POSSIBLE GEOMETRIES
III GEM WORKSHOP 2618/04/2012
NEXT STEP : TO MODEL GE2/1 WITH ALL INTERNAL AND EXTERNAL COMPONENTS
18 SUPERCHAMBERSPER SIDE
III GEM WORKSHOP 27
ENTRETIENS AVEC JOSÉ SALICIO, CHEFS DE GROUPE, PERSONNEL DEPT. IT THANK YOU FOR YOUR ATTENTION
REMARKS / QUESTIONS ?
18/04/2012
