Embed Size (px)
Citation preview
CH30 E1612- E4920
MRD
HANGER LOCATION
TYPICAL CALLOUTCH30 - ET 129 - R I
(Type) - (Load) - (Options)
HANGERHANGER
SELECTION LOCATION
EXTRA STRENGTH HANGER
**
CH3015° Tilt
1" DEFLECTIONSPRING HANGER
TYPE
01/03/14F595
Type CH30 is used where uncertain alignmentis anticipated during installation. At normal loadthe hanger rod will operated to a full 15° tilt inany direction from vertical centerline.
Spring rated deflection is 1".
The housings of these units arespecially reinforced for extra strength.
All housing sizes have been tested to carry5 times maximum load without failure.
The pre-compression rod is furnished withunits which have the "R" option, specify RodDiameter. This rod will extend about 3" belowthe Neoprene sleeve.
Maximum Rod Diameter (MRD)Threaded rod, nuts and washers by others.
**
*
Pre-compressionPlate, Rod, Nutsand WashersOption (R)
DeflectionIndicatorOption ( I )
Pre-compressionPlate, Rod, Nutsand WashersOption (R)
See NeopreneSleeve Detail
SMax. Load
CH30
(lbs)
DIMENSIONS (Inches)
W L MRD ØDET20ET42ET80
ET194ET129
ET255ET347ET473
ET940ET667
ET1326
E1612*
E2460*E2060*
E2980*
E4920*E4120*
4-3/4 3-5/8 2-1/2 1/2 1/2
6 5-5/16 4-1/4 3/4 5/8
5-7/8 4-3/473/4
7/87/8
8-1/4 10 41 1
9-1/2 78-1/2 1-1/8 1-1/8
MRD
S
L W
S
W
L
DeflectionIndicator
Option ( I )
SeeNeoprene
Sleeve Detail
LIGHT WEIGHT HANGERCH30 ET20 - ET255
BASIC HANGERCH30 ET347 - ET1326
NEOPRENE SLEEVE DETAIL
SteelWasher
Spring
Neoprene Sleeve
Hanger RodVertical Centerline
NeopreneSleeve
Spring
NEOPRENE SLEEVE DETAIL
Channel
Hanger RodVerticalCenterline
ØD
**ØD**ØD
Assoc. Member
JOB:
5572 ALHAMBRA AVE. LOS ANGELES CA, 90032PH 323-223-3882 FAX 323-223-7941
email: [email protected]
"CALL US - TO SET THINGS RIGHT"
CALIFORNIA DYNAMICS CORPORATION
TYPEDwg. No.
PREP By: Date
Date
DateCHKD By:
CUSTOMER:
TAG:
DO NOT SCALE DRAWING
