Air Conditioning Protection Kit
Anti-bending Plastic Optical Fiber Enhanced Security
CFS-AC2KIT
101 Wrangler, Suite 201 • Coppell, Texas 75019 • Phone:
469-635-6800 • Fax: 469-635-6822 • Toll Free: 1-888-694-STAR
(7827)
www.costarvideo.com
Features:
• Each kit contains: - 1 sensor - 660 feet of plastic optical
fiber (CFS-LW660) - 50 metal “eye” bolts (CFS-BOLT) - 2 FSMA
connectors (CFS-FSMA)
* Note: Termination kit required (CFS-TKIT)
Description: As copper prices increased over the past few years,
the occurrence of copper theft increased as well. The CFS-AC2KIT
kit provides protection for up to 5 air conditioning units
installed on a rooftop over a maximum distance of 300 feet. The kit
includes 660 feet of plastic optical fiber that is secured to the
air conditioning units using the 50 metal “eye” bolts provided. An
alarm is triggered when the plastic fiber loop is cut or bent in an
attempt to open the air conditioning units. This kit is designed to
offer enhanced security due to the higher sensitivity of the sensor
that can detect cutting, bending or excessive motion of the plastic
optical fiber.
http://www.costarvideo.com/
101 Wrangler, Suite 201 • Coppell, Texas 75019 • Phone:
469-635-6800 • Fax: 469-635-6822 • Toll Free: 1-888-694-STAR
(7827)
www.costarvideo.com
Specifications and design are subject to change without notice.
Conversions: 1” = 25.4mm Measurement conversions are
approximate.
CFS-AC2KIT Specifications
Power Source DC12V Consumption 140mA
Sensor Maximum Sensitivity -30dBm Alarm Contact NC 5.0A @ 240Vac
Plastic Fiber Lite Wire Simplex Tamper Mechanical Tamper Sensor
Operating Information
Temperature -4°F to 158°F (0°C to 50°C) Humidity 5% to 90%
Weight 1.41 lbs. (sensor only)
Dimensions 8.66” x 6.69” x 3.39” (220 x 170 x 86 mm)
Weatherproof Rating IP55
Certifications EMC2004 / 108 / CE RoHS, FCC (part 15)
Things NOT To Do During Installation
Warnings: - Do not step or pull excessively on the fiber. - Do
not bend the fiber in excess of 90°
or smaller than a 1” radius. - Do not attempt installation or
open the HVAC
panels before you turn the power OFF. - Do not drill holes in
any of the circuit boards,
control panels or switchboards. - Verify that you can place the
provided bolts in
the unit without obstruction of any other wiring. - Protect any
pipes or electrical cables by
winding the fiber around them. - Do not drill holes or place any
bolts near
electrical wiring due to risk of electrical shock.
http://www.costarvideo.com/
