Embed Size (px)
Citation preview
CERTIFICATEOF REGISTRATION
This is to certify that the management system of:
Interpower Group of CompaniesMain Site: 100 Interpower Avenue,Oskaloosa, Iowa, 52577, United States See appendix for additional sites and additional site scopes
has been registered by Intertek as conforming to the requirements of:
ISO 9001:2015The management system is applicable to:
Manufacture and distribution of power system components.
Certificate Number:95-382j
Initial Certification Date:18 May 1995
Date of Certification Decision:05 September 2019
Issuing Date:05 September 2019
Valid Until:21 September 2022
Calin MoldoveanPresident, Business Assurance
Intertek Testing Services NA, Inc.,900 Chelmsford Street, Lowell, MA 01851.USA.
In the issuance of this certificate, Intertek assumes no liability to any party other than to the Client, and then only in accordance with the agreed upon Certification Agreement. This certificate’s validity is subject to the organization maintaining their system in accordance with Intertek’s requirements for systems certification. Validity may be confirmed via email at [email protected] or by scanning the code to the right with a smartphone. The certificate remains the property of Intertek, to whom it must be returned upon request.
Page 1 of 2
APPENDIX TOCERTIFICATE OFREGISTRATION
This appendix identifies the locations covered by the management system of:
Interpower Group of CompaniesThis appendix is linked to the Main Certificate # 95-382j and cannot be shown nor reproduced without it.
Interpower Group of Companies
221 South Spruce Street,Lamoni, Iowa, 52577, United States
Manufacture and distribution of power system components.
Interpower Group of Companies
2900 South East 5th Street,Ames, Iowa, 50010, United States
Manufacture of electrical test equipment and product development.
Interpower Group of Companies
10 Kelvin Drive,Knowhill, Milton Keynes, Buckinghamshire, MK5 8NH, United Kingdom
Distribution of power system components.
In the issuance of this certificate, Intertek assumes no liability to any party other than to the Client, and then only in accordance with the agreed upon Certification Agreement. This certificate’s validity is subject to the organization maintaining their system in accordance with Intertek’s requirements for systems certification. Validity may be confirmed via email at [email protected] or by scanning the code to the right with a smartphone. The certificate remains the property of Intertek, to whom it must be returned upon request.
Page 2 of 2
