Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
CERTIFICATEOF REGISTRATION
This is to certify that the management system of:
Hamilton Kent Inc.Main Site: 77 Carlingview Drive, Toronto, Ontario, M9W 5E6, Canada See appendix for additional sites and additional site scopes
has been registered by Intertek as conforming to the requirements of:
ISO 14001:2015The management system is applicable to:
Main Site Scope: Design, manufacturing and marketing of elastomer gasket seals and custom elastomer products for various industries.
Certificate Number:0025134-02
Initial Certification Date:01 May 2015
Date of Certification Decision:24 April 2018
Issuing Date:01 May 2018
Valid Until:30 April 2021
Calin MoldoveanPresident, Business Assurance
Intertek Testing Services NA, Inc.,900 Chelmsford Street, Lowell, MA 01851.USA.
In the issuance of this certificate, Intertek assumes no liability to any party other than to the Client, and then only in accordance with the agreed upon Certification Agreement. This certificate’s validity is subject to the organization maintaining their system in accordance with Intertek’s requirements for systems certification. Validity may be confirmed via email at [email protected] or by scanning the code to the right with a smartphone. The certificate remains the property of Intertek, to whom it must be returned upon request.
Page 1 of 2
APPENDIX TOCERTIFICATE OFREGISTRATION
This appendix identifies the locations covered by the management system of:
Hamilton Kent Inc.This appendix is linked to the Main Certificate # 0025134-02 and cannot be shown nor reproduced without it.
Hamilton Kent LLC
740 Baxter LaneWinchester, Tennessee 37398 United States
Manufacturing and marketing of elastomer gasket seals and custom elastomer products for various industries.
In the issuance of this certificate, Intertek assumes no liability to any party other than to the Client, and then only in accordance with the agreed upon Certification Agreement. This certificate’s validity is subject to the organization maintaining their system in accordance with Intertek’s requirements for systems certification. Validity may be confirmed via email at [email protected] or by scanning the code to the right with a smartphone. The certificate remains the property of Intertek, to whom it must be returned upon request.
Page 2 of 2