System configuration and accessories System type
Optional accessories
1
1
Adhesive disk 10
10
10
10
1
5.5.1
5.3
5.4
24
04
20
31
0
20
00
21.5
9.3
42
0
5-4
42
0
24
04
20
31
0
20
00
21.5
9.3
42
0
5-4
42
0Size and installation7.
Beam number: 154
5.2 Sensor number: 32 pairs
The signal of emitter and receiver is open/The zero line is
open
2
No power supply
1. PrincipleThe system include the emitter and receiver, power
supply box, flexible cables.When the power is turned on, there will
generate infrared screen between two doors. If any ray of infrared
is blocked by any object or person, the doors stops closing
immediately and open to protect people.
2. Technical parameter2.1 Detector
Voltage: 12VDCPower: 5WResponse time: 61msHighest beam:
1860mmLowest beam: 25mmProtection distance: 0~5mAllow error:
Alternative LEDProtection grade: IP 65(moisture proof)
2.2 Power supply Output voltage: Rated power: 5WRelay: 1A,
125VAC/2A,30VDCOperating tem.: -20~85Size:154X50X31mm
2X12V
3. Installation3.1 Installation
Put the detector on the door edge, 10mm away from the
bottom.Mark the fixing holes on the door edge.Move away the
detector and drill 4mm holes on the edge.Fix the detector with
fixers in accessory bag.Connect two cables with power supply: model
368.
3.2 Sectional view(Pic 1)3.3 Installation figure(Pic 2)
4. Fault detection and solution4.1 Mode 368 power supply
PROBLEM SOLUTION
Green
Orange
Green
INDICATOR
System is normal
The beam is blocked or problems with the detector
Green LED is not lighted
Green LED is lighted
Orange LED is lighted
4.2 Receiver
INDICATOR PROBLEM SOLUTION
Both are not lighted
Light No light
Flash
Flash
No light
Light
Both are lighted
Wrong connection
The ray is blocked,The buzzer gets into alarm condition after 15
sencond' continuous blocking
Single ray is blocked
System is normal
CSN515Model
Manual
Guarantee
Cable clip R
Cable strip 10cm
Bolt, nut, washer
Power supply
Installation drawing
Picture 2
Cable
Door
Detector
Controller
Caution
Compulsory
CautionAvoid strongly bending or twisting the cables.
CompulsoryThe power to the controller is the same with the
lighting power in car.
Picture 1
Please ground the control good conductive
the box with earth wire to improvelight resistance and the
functionof the system.
Caution
NC
NOCOM
POWER INPUT
RELAY OUTPUT
50
AC 6
5285V
N
STATUS
TRAVELLING CABLE INPUT
125
2-4
138
Picture 3
3
Redundancy6.AC65~285VAC/DC16~65V
Input voltage:
One transmitter shielded after 120s
detected absent.
1 2
