Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
CBM3INSTRUCTION
MANUALTRAVEL GUARD
In the kit provided you will find the following components (fig 1) to be fitted to the section of the buggy (fig 2).
Travel guard.
Fig. 1 Travel guard kit parts
Fig. 2 Travel guard fitted to buggy
Travel guard
Screw driver
Place your bag and buggy on a flat surface and open until the handle is sitting parallel to the ground (fig 3).Note: It is important that the buggy is open in this exact position in order to fit the new travel guard.
It is important to understand that the small protruding edge on the travel guard marked “A” must fit into the opening marked “B” (fig 4).
Fig. 4 Line up travel guard as indicated
Fig. 3 Open handle
Handle parallel to ground, resting on leg.
B
A
Place section A into section B as indicated by arrows and apply pressure with your thumb (fig 5).
While continuing to apply downward pressure with your thumb, using the screwdriver provided, carefully guide section “A” into section “B” (fig 6).
Fig. 5 begin to fit travel guard
Fig. 6 Guide travel guard with screwdriver
Apply pressure
Apply pressure
Fit “A” and “B” together
Guide into “B”
Fig. 7 Fit top of travel guard to buggy
Fig. 8 Travel guard fitted to buggy
Once section “A” has been successfully inserted into section “B” you will be able to complete the fitting process by locking over the top tab of the travel guard (fig 7).
You have now completed the process and the buggy should look like this (fig 8).
Top tab locked over buggy
To see the CBM3 in action visit concoursegolf.com