CAFCO Topcoat 200 Petro Data Sheet - D032-0209

8/6/2019 CAFCO Topcoat 200 Petro Data Sheet - D032-0209

http://slidepdf.com/reader/full/cafco-topcoat-200-petro-data-sheet-d032-0209 1/4

CAFCO ® TOPCOAT 200 Acrylic Polymer Coating

For use with Cafco cementitious coatings

p e t r o c h e m i c a l a p p l i c a t i o n s

UniclassL68222

CI/SfB Vv

EPICE6112

www.promat-spray.com



2


INTRODUCTIONCAFCO® TOPCOAT 200 is a single pack, water based acrylic polymer for use as a water vapour

permeable topcoat with excellent adhesion. It may be applied by spray, roller or brush.

CAFCO® TOPCOAT 200 is applied over vermiculite and Portland cement based fire resistant coatings

that protect steel and concrete substrates against ingress from salt spray, washdown water, chemical

spills, rainfall and sprinkler deluge systems.

CAFCO® TOPCOAT 200 may also be used on masonry, brickwork and blockwork, whether dry or

damp.

ADVANTAGESCAFCO® TOPCOAT 200 does not blister when used on steel and concrete substrates because

of its water vapour permeability

Flexible, flame retardant, mould resistant, and helps reduce the carbonation rate of cement

based products.

UALITY ASSURANCEomat operates a quality system in

cordance with BS EN ISO 9001: 2000

d has received full accreditation toese standards.

erating to these standards means that all

ivities, which have a bearing upon quality,

e set out in written procedures.

stematic and thorough checks are made

all materials and their usage. Test

uipment is subjected to regular checks

d is referred back to national standards.

he information given in this data sheet is

sed on actual tests and is believed to be

pical of the product. No guarantee of

ults is implied however, since conditions

use are beyond our control.

Properties and performance

Colour and finish Usually matt white or greyPlease contact Promat for other colours

Thickness per coat 150-200 microns wet film thickness (WFT)68-90 microns dry film thickness (DFT)

Practical coverageDependent on surface texture, substrate porosity, applicationmethod and technique

Theoretical coverage 6.7m 2 /litre at 150 microns WFT5.0m 2 /litre at 200 microns WFT

Number of coatsNormally two coats. It is recommended that the first coat is adifferent colour from the second coat for identification purposes

Cure By air drying

Drying time

Touch dry ½ to 1 hour at 20°C and 50% RHFully dry 2 to 6 hours at 20°C and 50% RH Varies with ambient conditions, but high humidity, lowtemperature and low air change will hinder cure significantly

Water vapour transmission 25g/m 2 over 24 hours for 150 microns tested to BS 3177: 1959

Surface spread of flame Class 1 to BS 476: Part 7 on non-combustible substrates

Volume of solids 45%

Weight 1.4kg/litre



3


PACKAGING25 litre metal pails.

STORAGEProtect from frost, excessive heat (above 45ºC) and strong radiant sunlight.

SHELF LIFEMaximum 6 months in original sealed containers.

ENVIRONMENTALDo not discharge into drains, watercourses or soil.

HEALTH AND SAFETY Adequate ventilation must be provided

during use. Avoid contact with the skin and

eyes by using eye protection, gloves, barrier

cream and a face mask.

If the product comes into contact with the

skin, wash immediately with soap and

water. If the eyes are affected, flush with

plenty of water and seek medical attention

immediately.

A safety data sheet is available from Promatupon request.

Promat activities are conducted with due

regard to all statutory requirements with

appropriate safeguards against exposing

employees and the public to health and

safety risks.

Preparation

Typical substrates Concrete, sand-cement renders, masonry and Promatcementitious fire protective coatings

Substrate preparation

Surfaces to be coated must be free from oil, grease, visiblemoisture (including condensation), dirt, dust and mould.Cafco cementitious coatings should be surface dry before theapplication of CAFCO® TOPCOAT 200

Application

Methods

Stir CAFCO®

TOPCOAT 200 before use (do not thin) and applywith an industrial type airless spray or lambswool roller. Thelatter is not recommended on heavily textured surfacesCAFCO® TOPCOAT 200 may also be applied with a wide nylonor bristle brush in small (maximum 1m 2 ) areas only

Limitations

CAFCO® TOPCOAT 200 may be applied when the substrateand air temperatures are at least 5ºC and rising. Maximum airand substrate temperature is 40ºCSubstrate temperature should be at least 2ºC above dew pointtemperatureProtect from rain, hail etc until dry



HEAD OFFICE, BELGIUM

Promat International N.V.Bormstraat 242830 Tisselt Tel: +32 15 718 100Fax: +32 15 718 109Email:info@promat

international.comwww.promat-international.comwww.promat-tunnel.comwww.promat-marine.comwww.promat-spray.com

ASIA PACIFIC HEADQUARTERS,MALAYSIA

Promat International(Asia Pacific) LimitedUnit 19-02-01Level 2 PNB DamansaraNo.19 Lorong DungunDamansara Heights50490 Kuala Lumpur Tel: +60 3 2095 5111Fax: +60 3 2095 6111Email:[email protected]

AUSTRALIA

Promat Australia Pty. Limited1 Scotland Road, Mile End SouthSA 5031 Adelaide Tel: 1800 PROMATFax: +61 8 8352 1014Email:[email protected]

Promat Australia Pty. LimitedUnit 1, 175 Briens RoadNSW 2152 Northmead Tel: 1800 PROMATFax: +61 2 9630 0258Email:[email protected]

Promat Australia Pty. Limited3/273 Williamstown Road VIC 3207 Port Melbourne Tel: 1800 PROMATFax: +61 3 9645 3844Email:[email protected]

AUSTRIA

Promat Ges.m.b.H.Seybelgasse 131230 Wien Tel: +43 1 865 4501Fax: +43 1 865 3600Email:[email protected]

BELGIUM

Promat N.V.Kuiermansstraat 11880 Kapelle-op-den-Bos Tel: +32 15 713 351Fax: +32 15 718 229Email:[email protected]

CHINA

Promat China LimitedRoom 503, Block B, Qi Lin Plaza13-35 Pan Fu Road510180 Guangzhou Tel: +86 20 8136 1167Fax: +86 20 8136 1372

Email:[email protected]

Promat North China(Division of Promat China Limited) Room 1507 Building 5SOHO XiandaichengNo.88 Jianguo RoadChaoyang District100022 Beijing Tel: +86 10 8589 1254Fax: +86 10 8589 2904Email:[email protected]

CZECH REPUBLIC

Promat s.r.o.Ckalova 22/78416000 Praha 6 - Bubenec Tel: +420 2 2439 0811Fax: +420 2 3333 3576Email:[email protected]

DENMARK

Promat ApS Tåstrup StationscenterSelsmosevej 2, 1. floor2630 Tåstrup Tel: +45 7020 0482Fax: +45 7020 0483Email:[email protected]

FRANCE

Promat S.A.S.BP 66 Rue de L’Ammandier78540 Vernouillet Tel: +33 1 3979 6160Fax: +33 1 3971 1660Email:[email protected]

GERMANY

Promat GmbHScheifenkamp 1640878 Ratingen Tel: +49 2102 493 0Fax: +49 2102 493 111Email:[email protected]

HONG KONG

Promat International(Asia Pacific) LimitedRoom 1010, C.C. Wu Building302-308 Hennessy RoadWanchai Tel: +852 2836 3692Fax: +852 2834 4313Email:[email protected]

INDIA

Promat International(Asia Pacific) Limited(India Representative Office) 610-611, Ansal Imperial TowerC-Block, Community CentreNaraina Vihar, Naraina

110028 New Delhi Tel: +91 11 2577 8413Fax: +91 11 2577 8414Email:[email protected]

ITALY

Promat S.p.A.Corso Paganini 39/316125 Genova Tel: +39 010 248 8411Fax: +39 010 213 768Email:[email protected]

www.promat.it

MALAYSIA

Promat (Malaysia) Sdn. Bhd.Unit 19-02-01Level 2 PNB DamansaraNo.19 Lorong DungunDamansara Heights50490 Kuala Lumpur Tel: +60 3 2095 8555Fax: +60 3 2095 2111Email:[email protected]

NETHERLANDS

Promat B.V. Vleugelboot 223991 CL Houten Tel: +31 30 241 0770Fax: +31 30 241 0771Email:[email protected]

POLAND

Promat TOP Sp. z o.oul. Przeclawska 803 879 Warszawa Tel: +48 22 212 2280Fax: +48 22 212 2290Email:[email protected]

RUSSIA

Promat GmbHRepräsentanzul. Kantemirovskaya 58115477 Moscow Tel: +7 495 325 4268Fax: +7 495 231 7977Email:[email protected]

SINGAPORE

Promat Building System Pte.Limited10 Science Park Road#03-14 The AlphaSingapore Science Park II117684 Singapore

Tel: +65 6776 7635Fax: +65 6776 7624Email:[email protected]

SPAIN

Promat Ibérica S.A.C/ Velazquez, 41 - 2 Planta28001 Madrid Tel: +34 91 781 1550Fax: +34 91 575 1597Email:[email protected]

SWITZERLAND

Promat AGStationsstrasse 18545 Rickenbach-Sulz Tel: +41 52 320 9400Fax: +41 52 320 9402Email:[email protected]

UNITED ARAB EMIRATES

Promat Middle EastSuite 1805, Floor 18Festival City TowerP O. Box 123945, Dubai Tel: +971 4 232 9780Fax: +971 4 232 9781Email:[email protected]

UNITED KINGDOM

Promat UK Limited The Sterling CentreEastern Road, BracknellRG12 2TD Berkshire, Great Britain Tel: +44 1344 381 300

+44 1344 381 400 (technical)Fax: +44 1344 381 301Email: [email protected]

www.promat-spray.comPromat Ireland

43 Fitzwilliam SquareDublin 2, Ireland Tel: +353 1 6765778www.promat.ie

VIETNAM

Promat International(Asia Pacific) Limited(Vietnam Representative Office) Room 606 Giay Viet Plaza180-182 Ly Chinh Thang StreetWard 9, District 3

Hochiminh City Tel: +84 904 055 055Fax: +84 8 931 5964Email:[email protected]

Promat Worldwide An Extensive Global Service Network

D032-02/09

Documents

CAFCO Topcoat 200 Petro Data Sheet - D032-0209