06-33310-02

1. SPECIFICATIONDescription Specification

Structure 2-piece type with CV joint, spider, and rubber coupling

Weight below 12.0 kg

Joint type CV joint, spider, rubber coupling

Spider Numbers one (installed on center bearing side)

External diameter 24 mm

Overall size 62.5 mm

Dimension (Length x Dia.)

No.1 shaft (TM to spider) 1,069 x 60 mm

No. 2 shaft (spider to axle) 847.5 x 60 mm

Runout of tube (after installation) 0.3 mm

Unbalance 80g.mm @ 3,000rpm (second measurement: 120 g.mm)

U-joint Starting torque 0.3 to 0.7 Nm

Minimum starting angle 18

Amount of grease in CV joint 210+-10g

2. TIGHTENING TORQUEFastener Tightening torque

Bolt/nut for rubber coupling (rear axle side) 39.2 to 49.0 Nm

Bolt/nut for CV joint (transaxle side) 29.4 to 39.2 Nm

Mounting bolt for center bearing 58.8 to 68.6 Nm

06-4

1. OVERVIEWThe propeller shaft is a thin steel pipe which transfers the power from the transmission to the E-coupling, and has high resistance to torsion and bending. The propeller shaft has the universal joint (cross axle) mounted on the center of the shaft and splines for the slip joint on the E-coupling side to accommodate the height and length changes which occur as the shaft rotates at high speed.And the rubber bushing for center bearing in the center of the propeller shaft keeps the balance of the shaft and absorbs its vibration.

Function of propeller shaft

Transmits driving torque.Accommodates the angle change (universal joint / CV joint).Accommodates the axial length change (splines for the slip joint).

---

CV joint Universal yoke and center bearing

Universal yoke and rubber coupling

06-53310-02

2. COMPONENT

1 End cap 18 Plain washer

2 VL joint assembly 19 AL washer

3 Washer 20 Center bearing assembly

4 Bolt 21 Ball bearing

5 Circlip 22 Dust shield

6 Clamp (big) 23 Intermediate shaft

7 Boot 24 Fork yoke

8 Clamp (small) 25 Rubber coupling

9 Stub shaft 26 Alignment support

10 Bending absorber 27 Bolt

11 Paper damper 28 Washer

12 Tube yoke 29 Lock nut

13 Oil seal 30 Balance weight

14 Spider 31 Protecter

15 Bearing cap 32 Tube

16 Intermediate yoke 33 Tube

17 Bolt 34 Bending absorber

Do not remove the rubber coupling since the vibration balance could be improper once removed it.