Upload
others
View
37
Download
4
Embed Size (px)
Citation preview
Bucket Elevator Worksheet
Customer Information:
*Contact's Name:
*Project Address:
*Phone Number:
*Fax Number:
6 X 4 12 X 40 240 320 13 *Email Address:
Material Information:*Material Name:
*Material Bulk Density: lbs./cuft.
*Material Temperature: avg./max.
*Minus 200 mesh: %
*Material Size Range: in.
*Material Feed Rate: tph, cuft./hr.
*Material % Moisture:
*Material Characteristics:*Operating Hours Per Day: hrs./day*Additional Information:
*Class III Drive (Y/N): *Liner Type (in.): (AR steel, UHMW, etc.)*Total Lift: ft. *Additional Inspection Doors: quantity*Service Platform (Y/N): *Explosion Proof Motor/Switches (Y/N):*Access Caged Ladder (Y/N): ft. *Paint Specifications: (n.a., enamel, epoxy)*Electric Hoist/Push Trolley (Y/N): lb. cap. *Stainless Housing (Y/N):*Alignment Switches (Y/N): # of pairs *Sample Tray (Y/N):*Digger, etc. Buckets (Y/N): quantity *Tail Clean Out Shelve (Y/N):
*TEFC Electric Motors *Casing Housing Stiffners Every 5 Foot*Horsepower Range 1hp to 150 hp *Boltable 20 Foot Intermediate Sections*Shaft Mounted Class II Reducers *8 Foot Tall Tail (Boot) Section*Externally Mounted Pillow Block Bearings *Inspection Doors at Head and Tail Sections*Crowned Faced Lagged Drive Pulley *Clean Out Access at Base of Tail Section*Wing Type Tail Pulley with Screw Take-up *Boltable Cover at Feed Chute*Rubber Elevator Belting *Speed Sensor Located on Tail Pulley Shaft*Removable Dust Hood *Style AA Nylon Buckets*Removable Access at Tail Pulley *ABC Mounted Buckets to Belting*Casing Thickness Varies from 11ga. To .375 in.
*Abrasion Resistant Liners (Feed and Discharge) *Belt Alignment Switches*Class III Drives *Contoured Tail Clean Out Shelve*Double Row Configuration *Epoxy Paint System*Caged Access Ladders with Landings *Stainless Housing and Liners*Service Platform at Drive End *Explosion Proof Electrical Motors and Components*Service Winch and Trolley System *Digger Style Buckets*Additional Inspection Doors for Sampling
12 X 7 18 X 54
640 16
STANDARD ABC ELEVATOR SPECIFICATIONS
Note: Above Sizes Represent Single Row Elevators.For sizes not listed above, contact ABC Sales Dept.
SIZESCASINGSIZES
(in.)
BELTSPEED
(fpm)
TPH (based upon
100 pct)
BUCKET SPACING
(in.)
1780
10 X 6 16 X 48 270 1080 16
8 X 5 14 X 42 260
24 X 56 315 3200 18
320 18
Elevator Information:
Standard Equipment:
Optional Equipment:
Typical Applications: Industrial Sands, Limestone, Sand Gravel, Ores, Coal, Fine Powders, Granules, Flakes, Sugar, Peanuts, Rice, etc.
14 X 7 20 X 54 315 2160 18
16 X 8