Upload
rubbyrd
View
5
Download
1
Embed Size (px)
Citation preview
ROOF AND RAINWATER DOWN PIPE
ITEM DESCRIPTION UNIT QTY RATE AMOUNT
ROOF STRUCTURE
a. M2 400
b. 8º Profile pitch roof ,easured on plan (Gym room) M2 24
c. 3º Profile pitch roof measured on plan. M2 63
ROOF COVERING
d. M2 487
-
ROOF ACCESSORIES
e.
M 67
-
f. Steel Valey gutter, ditto. M 11 -
g. Fascia Board M 82 -
h. 200mm x 200mm Steel Gutter M 82 -
i. Steel Gutter Clip c/c 500mm Nos 164 -
k. 'C' Channel with 6100mm laid on roof (Gym room) Nos 6 -
l. L plate c/w bolt and nut (Gym room) Nos 24 -
ROOF INSULATION
g.
M2 487
E M 82
SUPPLY AND DELIVER TO SITE AND INSTAL MILD STEEL ROOF TRUSSES INCLUDING RAFTERS, WALL PLATES, TIES AND STRUTS INCLUDING ALL NECESSARY BOLTS AND NUTS, CUT, LABOUR, WELDED AND FRAME TOGETHER AND ALL NECESSARY PAINTINGS, LABOUR, MATERIAL, APPLIANCES ALL AS SHOWN AND DESCRIBED IN ENGINEER'S DRAWINGS
20º Profile pitch roof and hoisting to 4400mm from ground level. measured on plan.
"KLIPLOK ® 0.54MM TCT IMPROVED CLEAN COLOURBOND (R) XRW" METEL ROOF COVERINGS LAID ON MILD STEEL ROOF TRUSS AND PURLINS (ROOF TRUSS AND PURLINS MEASURED SEPERATELY) INCLUDING ALL NECESSARY ROOF ACCESSORIES AS SHOWN ON ARCHITECTURAL DRAWINGS.
Ridge capping (maximum girth 578mm up to 3 bends) in improved clean COLORBOND XRW steel with allowance made for lapping, comes complete with CS12-14 x 20mm (Class 3 fasterners conforming to AS3566.2 - 2002) OR OTHER APPROVED AND EQUIVALENT
Layer of double sided aluminium foil roofing paper laid on and including a layer of approved galvanised iron chichen wire mesh and lapped at joints (measured nett-no allowance made for laps)
KNOT, PRIME, STOP AND PREPARE AND APPLY ONE COAT PRIMER AND TWO COATS OF APPROVED GLOSS ENAMELLED PAINT TO:-
General surfaces of fascia board, exceeding 200 mm and not exceeding 300 mm wide
ROOF AND RAINWATER DOWN PIPE
ITEM DESCRIPTION UNIT QTY RATE AMOUNT
C1 / 12
ROOF AND RAINWATER DOWN PIPE
ITEM DESCRIPTION UNIT QTY RATE AMOUNT
RAINWATER DOWN PIPE
a. 100 mm Diameter (internal dimension) laid and jointed in trench M 0 -
b. M 0 -
c. No. 0 -
d. No. 0 -
e. 50mm dia nozzle No. 10
-
C1 / 13
UPVC PIPES TO B.S 4514, B.S. 5255 AND B.S. 4660 including all necessary jointing to other sizes of pipes, connectors, fittings and fixing as specified finished with and including three coats clear silicone paint :-
100 mm Diameter (internal dimension) fixed to wall and column including holderbats, part embedded to r.c. column.
EXTRAOVER for elbow and other requisite fittings (irrespective of fittings)
100 mm Diameter approved UPVC vent cowl grating fixed and set on top of rainwater downpipe (measured separately)
ROOF AND RAINWATER DOWN PIPE
ITEM DESCRIPTION UNIT QTY RATE AMOUNT
COLLECTION PAGE
From Page No. C1 / 12…………………..
From Page No. C1 / 13………………….. -
-
C1 / 14